Abstract:A single layer of Fe silicate was grown on Pd(111) and analyzed experimentally and theoretically. Following sequential deposition of SiO and Fe and annealing above 900 K in O2, an incommensurate but well-ordered, low-defect density layer was observed with low-energy electron diffraction and scanning tunneling microscopy (STM). The STM images revealed a moiré pattern due to the lattice mismatch between the relaxed oxide layer and the substrate, while high-resolution images showed a honeycomb structure consistent with a silicate layer with six-membered rings of corner-sharing SiO4 tetrahedra at its surface. Reflection-absorption infrared spectroscopy revealed a single peak at 1050 cm−1 due to Si–O–Fe linkages, while x-ray photoelectron spectroscopy data indicated a Si/Fe ratio of one, that the Fe were all 3+, and that the Si atoms were closest to the surface. Consistent with these experimental observations, first principles theory identified a layer with an overall stoichiometry of Fe2Si2O9 with the six-membered rings of SiO4 tetrahedra at the surface. One of the oxygen atoms appears as a chemisorbed atom on the Pd surface, and, thus, the layer is better described as Fe2Si2O8 atop an oxygen-covered Pd surface. The Fe2Si2O8 is chemically bound to the Pd surface through its oxygen atoms; and the passivation of these bonds by hydrogen was investigated theoretically. Upon hydrogenation, the adsorbed O atom joins the Fe silicate layer and thermodynamic analysis indicates that, at room temperature and H2 pressures below 1 atm, Fe2Si2O9H4 becomes favored. The hydrogenation is accompanied by a substantial increase in the equilibrium distance between the oxide layer and the Pd surface and a drop in the adhesion energy to the surface. Together the results indicate that a highly ordered 2D Fe silicate can be grown on Pd(111) and that subsequent hydrogenation of this layer offers potential to release the 2D material from the growth substrate.

Low Temperature Co Induced Growth of Pd Supported on A Monolayer Silica Film

STRUCTURE, THERMAL STABILITY, AND CO ADSORPTION PROPERTIES OF PD NANOPARTICLES SUPPORTED ON AN ULTRA-THIN SiO2 FILM

Temperature-mediated Structural Evolution of Vapor–phase Deposited Cyclosiloxane Polymer Thin Films for Enhanced Mechanical Properties and Thermal Conductivity

Crystal Facet Induced Single-Atom Pd/CoxOyon a Tunable Metal-Support Interface for Low Temperature Catalytic Oxidation

CO Induced Adatom Sintering in a Model Catalyst: Pd/Fe3O4

A Surface/Interfacial Structural Model of Pd Ultra-thin Film on SiC at Elevated Temperatures

Carbon and Silicon Related Surface Compounds of Palladium Ultrathin Films on SiC after Different Annealing Temperatures

CO oxidation on a single Pd atom supported on magnesia

Equilibrated Adsorption of CO on Silica-Supported Pt Catalysts

Imaging of low temperature induced SMSI on Pd/TiO2 catalysts

Low temperature homogenization in nanocrystalline PdCu thin film system

High dispersed Pd supported on CeO2 (100) for CO oxidation at low temperature

High dispersed Pd supported on CeO2 (1 0 0) for CO oxidation at low temperature

Thermally Stable Ultra-Small Pd Nanoparticles Encapsulated by Silica: Elucidating the Factors Determining the Inherent Activity of Noble Metal Catalysts

Preparation and Thermal Stability of Pd-doped Organic-inorganic Hybrid Silica Materials in Air Atmosphere

Experimental and theoretical investigation of the formation of two-dimensional Fe silicate on Pd(111)

Iron Carbidization on Thin-Film Silica and Silicon: A Near-Ambient-Pressure X-ray Photoelectron Spectroscopy and Scanning Tunneling Microscopy Study

Effect of Palladium Addition on Nickel Silicide Formation on Si (111)

Composition and structure of Pd nanoclusters in SiO$_x$ thin film

Deposition of Palladium Nanoparticles in SBA-15 Templated Silica Using Supercritical Carbon Dioxide

Sintering Inhibition of Flame-Made Pd/CeO2 Nanocatalyst for Low-Temperature Methane Combustion