Abstract:For the efficient and effective detection in automatic non-destructive testing (NDT) of weld defects, the NDT probe must stay aligned with the welds. It is essential to detect the deviation between the seam and the probe by means of weld recognition, in order to adjust the relative position between the workpiece and the probe. The traditional weld recognition method is suitable for real-time seam tracking when the geometric feature of the groove is distinct; however, it may fail when applied to the formed weld recognition. Other methods proposed by researchers are unsatisfactory in the signal-to-noise ratio of imaging, separation degree of visual features and efficiency of the processing algorithm. To solve these problems, this paper proposes a novel visual weld recognition method using two directional lights. The directional lights are projected onto the edges of the seam to produce the distinct man-made “light and shadow” (LS) features. In this paper, we first study the principles and sensing requirements of the LS features; then a stroboscopic circuit is established to lighten the two directional lights alternatively and meanwhile synchronizes the camera to capture images when each light is on. Afterwards, we propose an image processing algorithm based on thresholding and edge extraction to calculate the accurate edges of the seam. Finally, a weld detection platform is established and experiments on weld recognition and deviation correction are conducted. The experiment results show that the proposed detection method can recognize the edges of the seam effectively in 0.023mm accuracy. The time cost of the image processing algorithm is not more than 13ms. The proposed method is suitable for weld detection where the reinforcements of the seams are as low as 1mm. It expected to be applied to the automatic vision-guided NDT of weld defects.

Research on feature point detection of discontinuity welding seam

Identification of Discontinuous Welding Seam Using Laser Vision Sensor

Feature point extraction based on contour detection and corner detection for weld seam

Detection system of vision sensor of mobile robot for drainage holes in the hall

Research on a Feature Point Detection Algorithm for Weld Images Based on Deep Learning

An automatic feature point extraction method based on laser vision for robotic multi-layer multi-pass weld seam tracking

Weld seam feature point extraction using laser and vision sensor

A Method of Feature Extraction of Position Detection and Weld Gap for GMAW Seam Tracking System of Fillet Weld With Variable Gaps

Welding Quality Monitoring of High Frequency Straight Seam Pipe Based on Image Feature

Feature Extraction of Welding Seam Image Based on Laser Vision

Weld Seam Profile Detection and Feature Point Extraction for Multi-Pass Route Planning Based on Visual Attention Model

Underwater Wet Weld Seam Tracking Based on Passive Visual Sensor

An Easy Method of Image Feature Extraction for Real-Time Welding Defects Detection

A Practical Method for Weld Seam Position Detection.

Seam Feature Point Acquisition Based on Efficient Convolution Operator and Particle Filter in GMAW

An Adaptive Feature Extraction Algorithm for Multiple Typical Seam Tracking Based on Vision Sensor in Robotic Arc Welding

Study on identifying seam deviation information based on high speed rotating arc welding sensor

Research on the Model of Arc Noise in Welding Seam Tracking

Active visual continuous seam tracking based on adaptive feature detection and particle filter tracking

A Visual Weld Edge Recognition Method Based on Light and Shadow Feature Construction Using Directional Lighting

Study On Welded Seam Recognition Using Circular Laser Vision Sensor