Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Computer-aided Experiment of Using Real-Time Small Angle Light Scattering Image Processing Technique for Visual Characterization Flow Field of Polymer Melts

An Effective On-line Polymer Characterization Technique by Using SALS Image Processing Software and Wavelet Analysis

Grazing-incidence Small Angle X-Ray Scattering Studies of Nanoscale Polymer Gratings

Simulation and Visualization of Flow in A New Miniature Mixer for Multiphase Polymer Systems

Visualization and Simulation of Filling Process of Simultaneous Co-Injection Molding Based on Level Set Method

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Design for Novel Image Collection of Small Angle Laser Scattering

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Time-resolved small angle laser light scattering apparatus

A Novel Apparatus Combining Polymer Extrusion Processing and X-Ray Scattering

Modelling and simulation of moving interfaces in gas-assisted injection moulding process

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

New Approach to Develop a 3D Non-Isothermal Computational Framework for Injection Molding Process Based on Level Set Method

Numerical Simulation of Gas-Assisted Injection Molding Using CLSVOF Method

A Portable Extruder for in Situ Wide Angle X-Ray Scattering Study on Multi-Dimensional Flow Field Induced Crystallization of Polymer.

Investigation on the early and late stage phase-separation dynamics of poly(methyl methacrylate)/poly(α-methyl styrene-co-acrylonitrile) blends through rheological and scattering functions

Research on Flow Pattern and Molecular Mechanisms of Polymer Molten During Injection Filling Stage

Visualization of Macrophase Separation and Transformation in Immiscible Polymer Blends

Characterizing Nanoimprint Profile Shape and Polymer Flow Behavior Using Visible Light Angular Scatterometry

Numerical Simulation and Experimental Study of Polymer Micro Extrusion Flow

Recent Progress on Flash DSC Study of Polymer Crystallization and Melting