An investigation on discharge servo parameters and machining servo mode optimization of MS-WEDM
Huliang Ma,Yanqing Wang,Ming Lv,Shengqiang Yang
DOI: https://doi.org/10.1007/s00170-021-07594-2
IF: 3.563
2021-07-16
The International Journal of Advanced Manufacturing Technology
Abstract:Increasing the machining efficiency of middle speed wire electrical discharge machining (MS-WEDM) is usually through optimizing process parameters, but the discharge servo parameters of the servo controller can also be optimized to achieve the same purpose. This paper develops a multi-mode servo controller for MS-WEDM to investigate discharge servo parameters. Firstly, the structure and control principle of the servo controller are introduced, and the core functions are described in detail. Secondly, it introduces the discharge servo parameters that can be optimized: gap state threshold and feedback period. At the same time, the platform specifications and parameters for optimization experiments are introduced. Thirdly, the experimental scheme and result analysis of parameter optimization are described, and the optimized parameters are obtained. Finally, different machining experiments are carried out for the multi-mode of the servo controller to investigate the effectiveness and practicability of the different machining servo modes. In the parameter optimization and machining experiments, the recording function of the servo controller was used to draw the speed curve, and the servo response effects of different servo modes were obtained.
engineering, manufacturing,automation & control systems