Abstract:In this paper, numerical simulations of single-jet impingement cooling and double-jet impingement cooling processes of heated L-shaped steel are carried out using the VOF model. The SIMPLEC pressure–velocity coupling algorithm and realizable k-ε model are used for the solution. The effects of jet position, water flow, and jet distance in the single-jet condition are analyzed in the simulations. The distributions of impact pressure, turbulence kinetic energy, and Nusselt number were obtained, as well as the variation of the peak values of these three factors with the jet position, water flow, and jet distance. The water flow rate is 3–11 L/min, and the jet distance is 5–25 cm. The effect of the distance between the two nozzles on the jet cooling uniformity under the dual jet condition was also analyzed. The distance between the two nozzles was 15–45 mm. The results showed that the variation of water flow rate had a greater effect on the ability of jet cooling compared with the jet position and jet distance, and the heat transfer efficiency also increased gradually with the increase of water flow, but the increased rate of heat transfer efficiency decreased gradually. When the flow rate increased from 3 to 11 L/min, the maximum instantaneous cooling rates at 1/4 of the thickness of the short side upper side, long side upper side, short side lower side, and long side lower side positions increased by 38.9%, 48.5%, 48.2%, and 32.9%, respectively. To ensure that the jet does not shift, the jet distance should be less than or equal to 10 cm. In the case of the double jet, the nozzle distance is 1.5 cm, and the cooling uniformity of the cooling area between the two nozzles is better. The peak Nusselt number in the cooling area of each part under the double jet cooling condition increased by 5%, 9.4%, 10.2%, and 13.3%, respectively, compared with the single jet.

Three Dimension Numerical Simulation of Multi-Slot Gas Jet Impinging Heat Transfer

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Numerical simulation and experimental study of strip steel jet cooling

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Numerical simulation of single-jet impact cooling and double-jet impact cooling of hot-rolled L-shaped steel based on multiphase flow model

Numerical Investigation of the Cooling Flow Downstream of a Turbine Guide Vane Trailing Edge Slot

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Numerical simulation on three-dimensional subsonic impinging jet

Numerical Study on Stagnation Point Heat Transfer by Jet Impingement in A Confined Narrow Gap

Effect of Oblique Angle on Flow and Heat Transfer Characteristics of a Turbulent Impinging Slot Jet

Numerical Simulation of Heat Transfer Enhancement by Jet-Induced Longitudinal Vortices

Numerical Simulation of Swirling Burners Outlet Gas Field with Different Turbulence Model

Numerical Study of Flow and Heat Transfer of Impingement Cooling on Model of Turbine Blade Leading Edge

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Numerical Simulation of the Flow and Heat Transfer Characteristics of Sweeping and Direct Jets on a Flat Plate with Film Holes

Numerical Simulation Studies on Multiphase Flow in High Temperature Wind Tunnel Contractions and Experimental Sections

Modelling Of Impinging Flow And Heat Transfer In A Confined Narrow Gap

Survival of Chilean patients with systemic lupus erythematosus.

Comparison study of turbulence models in numerical simulation of multi-jets impinging injectors