Abstract:The adhesion force evolution of protein on surfaces with continuously varied hydrophobicity/hydration layer has not been completely clarified yet, limiting the further development of environmental applications such as membrane anti-biofouling and selective adsorption of the functional surfaces. Herein, chemical force spectroscopy using atomic force microscopy (AFM) was utilized to quantify the evolution of the adhesion forces of protein on hydration surfaces in water, where bovine serum albumin (BSA) was immobilized on an AFM tip as the representative protein. The stiffness, roughness and charge properties of the substrate surfaces were kept constant and the hydrophobicity was the only variant to monitor the role of hydrated water layers in protein adhesion. The adhesion force increased non-monotonically as a function of hydrophobicity of substrate surfaces, which was related to the concentration of humic acid, and independent of pH values and ionic strength. The non-monotonic variation occurred in the range of contact angle at 60-80 degrees due to the mutual restriction between solid-liquid interface energy and solid-solid interface energy. Hydrophobic attraction was the dominant force that drove adhesion of BSA to these model substrate surfaces, but the passivation of hydration layers at the interface could weaken the hydrophobic attraction. In contrast to the measurements in water, the adhesion forces decreased as a function of surface hydrophobicity when measured in air, because capillary forces from condensation water dominated adhesion forces. The passivation of hydration layers of protein was revealed by quantitatively determining the evolution of adhesion forces on the hydration surfaces of varying hydrophobicity, which was ignored by traditional adhesion theory. (c) 2021 Elsevier Inc. All rights reserved.

Adhesion of Iron Oxide to Silica Studied by Atomic Force Microscopy

Interaction Forces Between Muscovite and Silica Surfaces in Electrolyte Solutions Measured with Afm

The Dissociated Amorphous Silica Surface: Model Development and Evaluation.

The Water-Amorphous Silica Interface: Analysis Of The Stern Layer And Surface Conduction

Investigation of interparticle forces in natural waters: effects of adsorbed humic acids on iron oxide and alumina surface properties

Surface ionization and complexation at the oxide/water interface II. Surface properties of amorphous iron oxyhydroxide and adsorption of metal ions

Correlation between Electrostatic and Hydration Forces on Silica and Gibbsite Surfaces: An Atomic Force Microscopy Study

Forces between colloid particles in natural waters

Complex Chemical Force Titration Behavior Of Amine-Terminated Self-Assembled Monolayers

Different Evolution Behaviors of Adhesion Force with Relative Humidity at Silica/Silica and Silica/Graphene Interfaces Studied using Atomic Force Microscopy

Interfacial Stoichiometry and Adhesion at Metal/α‐Al2O3 Interfaces

Adhesion of Escherichia coli onto quartz, hematite and corundum: extended DLVO theory and flotation behavior

Time-Dependent Dynamic Behaviors of a Confined Liquid to Achieve Tailored Adhesion Force with Repeated Contacts Revealed by Atomic Force Microscopy

Adhesion force evolution of protein on the surfaces with varied hydration extent: Quantitative determination via atomic force microscopy

ATR-FTIR Spectroscopy Reveals Bond Formation During Bacterial Adhesion to Iron Oxide

Adhesion forces due to nano-triboelectrification between similar materials

A context model for knowledge-intensive case-based reasoning

Reducing adhesion force by means of atomic layer deposition of ZnO films with nanoscale surface roughness.

Research of adhesion force between dust particles and insulator surface using atomic force microscope

Contact time dependence of adhesion force studied at low, moderate, and high relative humidities on AFM: Influence of surface hydrophilicity

Adhesion Force Measurement of Electrical Insulating Materials by Atomic Force Microscopy