Abstract:The reasonable and rapid prediction of turbine performance based on design targets such as mass flow rate and pressure ratio is indispensable in the preliminary and conceptual design stage for gas turbine engines in the aviation and power generation industry. However, the lack of detailed geometrical and aerodynamic parameters in this stage significantly challenges the reasonable evaluation of turbine characteristics. The present work proposes a rapid prediction method of axial turbine performance by coupling the inverse design and direct analysis. Firstly, according to the one-dimensional mean line design theory with empirical loss and deviation correlation models, the basic aerodynamic and geometrical parameters are quickly obtained by solving the inverse problem to fulfill the design targets such as mass flow rate and pressure ratio with optimized efficiency. Then, by adopting the loss and deviation correlation models in the off-design conditions, the turbine characteristics in a wide range of operating conditions are obtained by solving the direct analysis problem. Thus, the reasonable and rapid prediction of the turbine characteristics can be realized by coupling the inverse design with direct analysis. Based on the built prediction model, the effect of various deviation models on the predicted turbine characteristics, which was not systematically investigated in previous studies, is clarified by comparing the predicted performance with published test results. Finally, an optimization method of the empirical coefficients in turbine loss and deviation models based on the Genetic Algorithm (GA) is introduced. This method employs optimization theory and existing experimental data to improve the prediction accuracy. The results show that the averaged prediction discrepancies of output powers and mass flow rates in a wide range of operating conditions are no more than 2% and 2.5% for test cases after the optimization of model coefficients. Therefore, this optimization method is expected to be used for updating the empirical coefficients to improve the model prediction accuracy, accompanying the evolution of turbine design strategy at present or in the future.

Prediction of the Secondary Air System's 1D Heat Transfer Characteristics in the Gas Turbine

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

The Numerical Analysis Of Ventilation And Temperature Fields For A Bulb Tubular Turbine Generator

Coupled Heat Transfer Predictions of Thermal Environment for a Turbine Rotor

The Application Of Discontinuous Galerkin Methods In Conjugate Heat Transfer Simulations Of Gas Turbines

Simulation of the secondary air system of turbofan engines: Insights from 1D-3D modeling

Towards Predictive Maintenance of a Heavy-Duty Gas Turbine A New Hybrid Intelligent Methodology for Performance Simulation

Multidimensional analysis and performance prediction of heavy-duty gas turbine based on actual operational data

Numerical Prediction of Transitional Features of Turbulent Forced Gas Flows in Circular Tubes with Strong Heating

Numerical Investigations of Flows and Heat Transfer in Turbine Disk Cavities

One-dimensional Aerothermodynamics Modelling for Gas Turbine Design Considering Effect of Thermal Barrier Coating

Axial Thrust, Disk Frictional Losses, and Heat Transfer in a Gas Turbine Disk Cavity

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine

Numerical Prediction of Multi-Stage Axial Compressor Performances

Three-Dimensional Aerodynamic Optimization of Turbine Blade Profile Considering Heat Transfer Performance

Rapid Performance Prediction Model of Axial Turbine with Coupling One-Dimensional Inverse Design and Direct Analysis

Through Flow Calculations For Convective Cooled Turbines

Data-Driven Conjugate Heat Transfer Analysis of a Gas Turbine Vane

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities

Multi-Dimensional Platform For Cooling Design Of Air-Cooled Turbine Blades

Numerical simulation on viscous flow in the secondary flow path of a turbine sealed cabin