Microstructure and Mechanical Properties of GH3535 Superalloy Joints Using Electron Beam Welding
Baoyun Ma,Sai Wang,Huaxin Li,Wenjian Zheng,Yinghe Ma,Chuanyang Lv,Sendong Ren,Yanming He,Jianguo Yang
DOI: https://doi.org/10.1002/adem.202401282
IF: 3.6
2024-08-31
Advanced Engineering Materials
Abstract:In order to achieve low‐stress and small‐deformation welding of the thin‐walled structure of the fourth generation of nuclear power, the thin plate of GH3535 alloy is welded by electron beam welding (EBW), and the mechanical properties and microstructure evolution of the welded joints are characterized and analyzed, and the relationship between the microstructure evolution and mechanical properties of the joints is established according to the test results. To achieve low‐stress and small‐deformation welding of thin‐walled structures for the fourth‐generation nuclear power plants, GH3535 superalloy is welded to itself using electron beam welding (EBW). The microstructure and mechanical properties of the GH3535 superalloy joints are characterized by scanning electron microscopy (SEM), energy dispersive spectrometer (EDS), hardness, and tensile tests. A macro‐defect‐free GH3535 superalloy joint could be obtained using 22 mA welding beam current under 65 kV welding voltage with 300 mm min−1 welding speed. Different sub‐grain solidification morphologies are observed at the weld zone because of the influence of composition undercooling on the solidification process of the weld pool. The M6C type carbides formed in the weld zone and heat‐affected zone (HAZ) take place eutectic transformation under the action of thermal cycles. The eutectic transformation of M6C has no significant effect on the strength of HAZ, whereas this phenomenon is beneficial to hinder the dislocation movement in the weld zone, thereby promoting the tensile strength of the joint. The Vickers hardness of weld zone and HAZ are 250.6 and 252 HV0.5, remarkably lower than that of the base metal (261.2 HV0.5), due to the grain coarsening in those zones. The tensile strength of the GH3535 superalloy joint reached 791 MPa, ≈93.5% that of the base metal, with the fracture occurred in the weld zone.
materials science, multidisciplinary