Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

3D Viscoelastic Simulation of the Interface in Coextrusion Process of Polymers

3-D Simulation on the Melt Interface in Co-extrusion Die

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

Numerical Simulation of the Non-isothermal Viscoelastic Flow Past a Confined Cylinder

Three dimensional simulation of viscoelastic polymer melts flow in a cast film process

Modelling and simulation of moving interfaces in gas-assisted injection moulding process

Simulation of Stress Distribution Near Weld Line in the Viscoelastic Melt Mold Filling Process

Analysis and experimental studies of polymer coextrusion flow

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Numerical modelling of the viscoelastic polymer melt flow in material extrusion additive manufacturing

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

Numerical Simulation of Polymer Filling Process by a Combined Finite Element/discontinuous Galerkin/level Set Method

Simulation of Residual Stress in Viscoelastic Mold Filling Process

Visualization and Simulation of Filling Process of Simultaneous Co-Injection Molding Based on Level Set Method

New Approach to Develop a 3D Non-Isothermal Computational Framework for Injection Molding Process Based on Level Set Method

Numerical Simulation of Moving Interfaces in Gas-Assisted Injection Molding Process by Level Set Approach

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Research on Modeling of Hot Embossing Polymeric Microfluidic Chip

Numerical Simulation of Gas-Assisted Injection Molding Using CLSVOF Method

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding