Abstract:The effects of the impregnation of three types of inorganic fillers into polyvinylidene fluoride (PVDF) polymer membranes on the gas permeability and selectivity of these membranes were studied theoretically and experimentally. Permeabilities of He, CO2, O2, and N2 through three types of mixed matrix membranes (MMMs) based on PVDF, that is, PVDF/SiO2, PVDF/MCM‐41, and PVDF/4A MMMs, were experimentally measured and theoretically predicted using Maxwell, Higuchi, Bruggeman, and Bottcher‐Landauer models. Theoretical permeabilities of the PVDF/SiO2 MMMs using the above four models predicted the results in the following order: Maxwell model>Bruggeman model>Bottcher model>Higuchi model. However, this sequence was reversed for PVDF/MCM‐41 MMMs. The nonporous SiO2, mesoporous MCM‐41 and zeolite 4A inorganic fillers had effects on the permeabilities of the challenge gases for the PVDF/SiO2, PVDF/MCM‐41, and PVDF/4A MMMs but had no effects on the selectivities of the MMMs. The experimental permeabilities of the MMMs showed that there were no significant differences among the three types of MMMs despite that the inorganic fillers, that is, SiO2, MCM‐41, and zeolite 4A, had distinct dissimilar properties such as pore structures and particle sizes. Density measurements indicated that some voids were present in the polymer/particle interfaces. Based on the density measurement results, the void volume fractions of the resulting MMMs were calculated. An equation is derived to determine the void thickness of the MMM in terms of its physical properties and hence this proposed equation can substitute the difficult task of measuring such void thickness through any microscopy techniques. The Maxwell, Higuchi, Bruggeman, and Bottcher‐Landauer models could not predict the actual gas permeabilities of the PVDF MMMs. By taking the effects of crystallinity and immobilization factor on gas permeability into consideration, the extended modified Maxwell model showed good agreement with the experimental gas permeabilities of the resulting MMMs, indicating that the model did capture the essence of the gas transport behaviors through the MMMs. © 2013 American Institute of Chemical Engineers AIChE J, 59: 4715–4726, 2013

Influence of wall thickness and filling gas procedure on permeability of hollow glass microsphere

Effect of Surface Erosion on Permeability of Hollow Glass Microspheres

Gas Permeation Performance of Cellulose Hollow Fiber Membranes Made from the Cellulose/n‐methylmorpholine‐n‐oxide/h2o System

Study of helium permeability for silica microspheres

Permeation and photo-induced outgassing of deuterium in hollow glass microspheres doped with titanium

Gas-driven Permeation of Deuterium Through Tungsten with Different Microstructures

Experimental and Computational Study of the Thermal Insulation Properties of Hollow Glass Microspheres

Influences of the Perforation on Effective Transport Properties of Gas Diffusion Layers

Development on Preparation Technology of Hollow Glass Microspheres

Permeation of Compressed and Supercritical Fluids Through Porous Membranes

Filling Hollow Glass Microspheres with Ar by Method of Gas Diffusion

Theoretical and Experimental Studies on the Gas Transport Properties of Mixed Matrix Membranes Based on Polyvinylidene Fluoride

Non-equilibrium Molecular Dynamics Simulation on Pure Gas Permeability Through Carbon Membranes

Gas permeability evolution of unsaturated GMZ bentonite under thermo-mechanical effects

Effect of Various Surface Conditions on Nanochannel Flows Past Permeable Walls

Research on Effective Thermal Conductivity of Hollow Glass Microspheres under Vacuum at Low Temperature

Influence of perforated gas diffusion layer micropore shape parameters on water removal in a proton exchange membrane fuel cell flow channel

Transient Experiment on the Permeability of Micro-nano Porous Materials

Gas Permeation Behavior Across Expanded Polytetrafluoroethylene Membranes

Experimental measurement and clustered equal diameter particle model of permeability with methane hydrate in glass beads

Effect of hollow glass microspheres on transverse properties of carbon fiber reinforced epoxy composites