Abstract:Cu2S, consisting of Earth-abundant and eco-friendly elements, is a promising candidate for thermoelectric energy conversion. The stoichiometric Cu2S has intrinsically low thermal conductivity together with meagre electrical conductivity. Herein, in order to improve the electrical properties, we develop a facile solvothermal method for synthesizing a series of Cu2–xS with tunable phase compositions. With reduction in the CuCl/Na2S molar ratio in the solution precursors from 2:1 to 1.75:1, the solvothermal products transform from single-phase Cu2S into Cu2S–Cu1.96S composites, which are preserved in the hot-pressed pellets. The decreased CuCl/Na2S molar ratio results in increased room-temperature Hall carrier concentration, leading to enhanced electrical conductivity. Specifically, the pellet corresponding to the 1.75:1 CuCl/Na2S precursor ratio obtains a power factor of 8.04 μW cm–1 K–2 at 815 K, which is ∼735% of the value obtained by stoichiometric Cu2S. Along with the moderate thermal conductivity, this sample achieves an enhanced zT value of 0.87 at 815 K, representing a ∼250% increase when compared to stoichiometric Cu2S. This study demonstrates an effective strategy in enhancing the thermoelectric performance of solution-synthesized Cu2S-based materials by phase tuning.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c13050.Extra XRD, SEM, TEM, EPMA, EDS, and WDS results on the synthesized samples, calculated weight fraction of Cu1.96S in the samples, Rietveld refinement results, thermoelectric property comparison, and zT values of the Cu2S–Cu1.96S-3 pellets in the first three cycles (PDF)This article has not yet been cited by other publications.

Low-temperature Synthesis and Characterization of the Single Chalcopyrite Phase CuInS2 Compound by Vacuum Sintering Method

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Chemical synthesis of Cu(In) metal inks to prepare CuInS2 thin films and solar cells

CuSbSe 2 -assisted sintering of CuInSe 2 at low temperature

CuInS 2 thin films obtained by solid-state sulfurization

Temperature Dependence of Microstructure and Physical Properties of Cuinse2 Prepared by Rapid Synthesis Reaction

Synthesis and Characterization of CIGS Powder

Cu–In Intermetallic Compound Inks for CuInS 2 Solar Cells

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

Preparation of perfect chalcopyrite ordering CuInS 2 thin films by high-temperature sulfurization of metal oxide nanoparticles

Synthesis of CuInSe 2 Nanoparticles by Phase Transformation of in 2 Se 3 Via Wet Chemical Process in Low Temperature

Solvothermal Synthesis and Characterization of Chalcopyrite CuInSe2 Nanoparticles

A Mild Solvothermal Route to Chalcopyrite Quaternary Semiconductor CuIn(SexS1 − X)2 Nanocrystallites

Synthesis of hexagonal structured wurtzite and chalcopyrite CuInS 2 via a simple solution route

Effects of Preparation Conditions on the CuInS2Films Prepared by One-Step Electrodeposition Method

Synthesis and Characterization of Ce-Incorporated Cuins2 Chalcopyrites

Experimental and theoretical study of stable and metastable phases in sputtered CuInS${_2}$

Preparation and Properties of CuInS2 Thin Film Deposited by Single-Source Thermal Evaporation

Synthesis and Physical Properties of Solar Material Cu1+Xin1-Xse2

Temperature‐dependent Raman Investigation of CuInS2 with Mixed Phases of Chalcopyrite and CuAu

Phase Tuning for Enhancing the Thermoelectric Performance of Solution-Synthesized Cu 2– x S