Abstract:To improve the casting quality as well as the casting efficiency during the casting process, the effect of the interaction of process parameters and system structural parameters on the shrinkage volume and efficiency of the casting was investigated in this paper by using the response surface method for the simulation prediction of A356 alloy sand casting. The relationship between variables and response (shrinkage volume, solidification time) was established by Box-Behnken Design with pouring temperature (650–710 °C), mold preheating temperature (200–300 °C), width/thickness ratio of cross-section of sprue (1.2–1.5), width/thickness ratio of inner sprue section (2–4) and length/diameter ratio of straight sprue (1.5–2.5) as variables by the response surface method. The results are then optimized, and the optimal solution is selected by the NSGA-II algorithm and TOPSIS method. The results show that the changes in the cavities of the optimized and improved pouring system enhance the flow of the metal fluid and make the filling more complete. The gentle cooling of temperature is conducive to heat dissipation and layer-by-layer sequential solidification, which can effectively eliminate the casting's internal shrinkage loosening and shrinkage holes defects, thus forming a dense casting with good performance. After solving the optimized parameters and improving the pouring system, the solidification time (integrated solidification time) was reduced from 129.24 to 88.10s, and the shrinkage volume was reduced from 9.68 to 4.06 cm 3 .

Design and optimization of casting system of die casting die for magnesium alloy based on numerical simulation

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Process Optimization of Low-pressure Die Casting of Aluminum Alloy Wheel based on Taguchi Method

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Study and Application of Cae Simulation in Die-Casting Die Design

Die-Casting Die Design Based on the Application of Cae Simulation

Optimum Design and Analysis of Metal Delivery System for Magnesium Alloy Plates with Twin-Roll Casting Process

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical simulation on semi-solid die-casting of magnesium matrix composite based on orthogonal experiment

Study on a CAD/CAE system of die casting

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Research and Application of Foundry CAD/CAE System

Numerical Simulation and Optimization of Investment Casting for Complex Thin-walled Castings

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Optimization of Engine Block Casting Process Based on New Aluminum Alloy Material of Al–Si–Cu System

Optimization of Gating System Design for Die Casting of Thin Magnesium Alloy-Based Multi-Cavity LCD Housings

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Progress in numerical simulation of solidification process of shaped casting

Stress and Distortion Simulation of Magnesium Alloy Die Casting Dies