Abstract:Titanium carbide is a good candidate for tritium permeation barrier in a fusion reactor. However, its oxidation susceptibility and the mismatch between the ceramic coating and substrate are still a challenge. In this study, a promising candidate as a hydrogen permeation barrier, comprising a titanium-based ceramic TiO2/TiCx composite coating, was proposed. The preparation process of this TiO2/TiCx composite coating involves two steps of carbon ion implantation and oxidation under ultra-low oxygen partial pressure. According to the results, the optimal oxidation temperature for TiO2 coating is 550 degrees C, with the increase of the oxidation temperature, the particles on the surface of the oxide layer become coarse and loosely arranged, and the protective performance of the oxide layer is greatly reduced. The hydrogen barrier permeation behavior of the composite coating in a fusion reactor was simulated via hydrogen plasma discharge environment, the results show that the hydrogen barrier permeation performance of the composite is significantly better than that of a single TiO2 coating. In addition, the coatings treated with hydrogen plasma showed a certain self-repairing performance through the diffusion growth of the TiCx layer. These findings illustrate a novel method for preparing composite coatings to restrain hydrogen permeation, providing insight into the development of hydrogen permeation barrier materials. (C) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Effects of Hydrogen Ion Implantation on TiC-C Coating of Stainless Steel

Effect of Heating on the Behaviors of Hydrogen in C-Tic Films with Auger Electron Spectroscopy and Secondary Ion Mass Spectroscopy Analyses

Chemical Bonding States of TiC Films Before and after Hydrogen Ion Irradiation

Microanalysis on the Hydrogen Ion Irradiated 50 Wt Pct TiC-C Films

The Effect of Contaminating Oxygen on 50%Tic-C Films Before and after Hydrogen Ion Irradiation

Effect of Heating on Hydrogen Retention in C-SiC Coatings

Effect of Heat Treatment on Surface Composition of Hydrogen Implanted C-SiC Coatings

Corrosion and Mechanical Properties for Cr-coated CSS-42L Bearing Steel after Ti and C Ions Co-Implantation

Effects of Titanium-Implanted Dose on the Tribological Properties of 316L Stainless Steel

Investigating the Effect of Poly-tetra-fluoro-ethylene on the Cavitation-Erosion and Corrosion Resistance of HVOF Sprayed TiC Coatings on Stainless Steel

Hydrogen trapping and embrittlement of titanium- and vanadium carbide-containing steels after high-temperature hydrogen charging

Effect of carbon contamination on hydrogen uptake of titanium film

The Hydrogen Resistant Behaviors Of The Sic Coatings On Stainless Steel By Different Preparation Methods

Fabrication of Titanium Carbide Film on Bearing Steel by Plasma Immersion Ion Implantation and Deposition

Hydrogen Resistance Property of Surface N~+ Implanting SiC Coating

Influence of titanium concentration on mechanical properties and wear resistance to Ti6Al4V of Ti-C:H on cemented carbide

Deposition of Titanium Carbide Catalytic Films on Vanadium Foils by Ion Beam Sputtering for Hydrogen Separation and Purification

Effect of Co Ion Implantation on Friction and Wear Behavior of Stainless Steel

EFFECT OF C2H2 FLOW RATE ON THE DEPOSITION OF TI-TIC-TIC/DLC GRADIENT NANO-COMPOSITE FILM ON NITI ALLOY

Preparation and Hydrogen Penetration Performance of TiO2/TiCx Composite Coatings

Effect of Hydrogen on Microstructure and High Temperature Deformation of (tib + TiC)/Ti–6Al–4V Composite