The Pretreatment of Sugarcane Molasses and Analysis on Component

Xiang-ru WANG,Shu-juan YU

DOI: https://doi.org/10.3969/j.issn.1000-9973.2010.02.012

2010-01-01

Abstract:Sugarcane molasses was the byproduct of the sugar mill in process.It was an excellent source of mineral,and active ingredients like falconoid as well as polyphenol,which could be developed into high-added value product.However,the components of molasses were complicated,which would hinder the quality of the products.Therefore,some pretreatment was needed to get rid of the colloid and ash from the molasses.In present study,single-factor experiment and orthogonal experiment were designed to optimize the pretreatment of the molasses.As the results showed,the optimal condition of pretreatment on molasses was as follows,6 times dilution,adding phosphoric acid 250×10-6,adjusting pH with lime to 7,mixing floc 5 ×10-6,put in the 85 ℃ water bath for 10 min to precipitate,then,high speed centrifuge was set to separate impurity.The supernatant was collected and was adjusted pH by sulphuric acid to 2,then acidolysis in 100 ℃ water bath for 90 min Finally,GC/MS was taken to analyze the difference on the component of molasses before and after pretreatment.