Elastic Behavior of Ldpe/Hepe Blend Melts in Capillary Extrusion

JZ Liang

DOI: https://doi.org/10.1002/1097-4628(20001024)78:4<759::aid-app90>3.0.co;2-s

IF: 3

2000-01-01

Journal of Applied Polymer Science

Abstract:The studies of the elastic behavior in the capillary flow of LDPE/HDPE blend melts were carried out at a test temperature range from 180 to 200 degrees C and at an apparent shear rate of about 25-120 s(-1). The end-pressure drop (Delta P-end) increased nonlinearly with increasing wall shear stress (tau(omega)) and achieved a minimum value at a weight fraction (phi(HD)) of HDPE of 50%. The die-swell ratio (B) increased basically linearly with increasing tau(omega) or Delta P-end and achieved a maximum value at phi(HD) of 50%. With the addition of the die length-diameter ratio, the values of B were decreased linearly. At a low shear rate, the temperature sensitivity of the melt die-swell was more significant than at a high shear rate. With increasing phi(HD), B increased when phi(HD) <50%, then decreased. B reached a maximum value at phi(HD), of 50% and a fixed apparent shear rate. This phenomenon may be explained by using the theory of viscoelastic competition between components of polymer blend melts. Furthermore, the first normal stress difference (N-1) of the sample melts was estimated by using an equation published in a previous work. The results showed that B increased linearly with increasing N-1. (C) 2000 John Wiley & Sons, Inc.