Abstract:For a nonisothermal blackbody cavity, different reference temperatures have influence on the calculation of effective emissivity. Previous studies proposed a weighted average method which can be indicated by a priori to calculate the reference temperature. However, these studies did not mention how to define the weight function but used some arbitrary temperature or the temperature of a fixed position like the central bottom of the cavity as the reference temperature. In this study, a quantitative analysis and calculation method, which is implemented in the Monte Carlo method based optical simulation software Tracepro, is proposed to define the weight coefficients and optimize the reference temperature. To do so, in the Tracepro software, a surface source is placed in front of the cavity opening and emits radiation to the blackbody cavity. The radiation from this surface source can be absorbed or reflected many times in the cavity, and finally the incident radiation distribution in the cavity can be obtained. According to the principle of light path reversibility, the normalized incident radiation can be considered as the contribution of its position to the effective emissivity. In the experiment, the actual temperatures of two different-shaped blackbody cavities are measured with the non-contact method in 873 K temperature. By dividing the inner surface of each blackbody cavity into several regions based on the positions of the actually measured temperature points, the incident radiation from the surface source to each segmented region is calculated and normalized to the total incident radiation across all regions as its weight coefficient; the reference temperature is the sum of the weighted temperature (by multiplying each weight coefficient with its measured temperature) in each region. Different from previous studies, this study optimizes the reference temperature by considering the contribution of the whole cavity to the effective emissivity, which should be more consistent with the actual situation. Moreover, the influences of different shapes of the blackbody cavities, different radiation characteristics of the inner surface materials and different viewing conditions of the effective emissivity on the reference temperature are discussed and compared. The results suggest that the optimization of reference temperature has close link with above factors and thus should be calculated individually.

Radiant Characteristics Evaluation and Structural Parameter Optimization Design of V-Grooved Surface Blackbody

Structured thermal surface for radiative camouflage

Radiative Thermal Coats for Passive Temperature Management

Study of an Improved Two-Colour Method Integrated with the Emissivity Ratio Model and Its Application to Air- and Oxy-Fuel Flames in Industrial Furnaces

A method for optimizing the reference temperature in the effective emissivity calculation of nonisothermal blackbody cavities

Establishment and test verification of inf rared heat source equation in automated placement

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach

A Thermal Radiation Modulation Platform by Emissivity Engineering with Graded Metal-Insulator Transition

Theoretical investigation on spectral emissivity of thermal control coatings with optical-rough surface

Research on Large-Area Blackbody Radiation Source for Infrared Remote Sensor Calibration

Numerical study on impact of non-heating surface temperature on the heat output of radiant floor heating system

Numerical Investigation on Uniformity of Heat Flux for Semi-Gray Surfaces Inside a Solar Cavity Receiver

Wrinkled surface microstructure for enhancing the infrared spectral performance of radiative cooling.

Measurement of Surface Scattering Characteristics of Black Materials in Thomson Scattering System

Numerical analysis of the heat transfer of radiant tubes and the slab heating characteristics in an industrial heat treatment furnace with pulse combustion

Modeling approach and numerical analysis of a roller-hearth reheating furnace with radiant tubes and heating process optimization

Combined use of blackbody and infrared radiation for accurate measurement of temperature field of aluminum alloys

Measurement On The Surface Temperature Of Dispersed Chars In A Flat-Flame Burner Using Modified Rgb Pyrometry

Radiative Properties of Semitransparent Silicon Wafers With Rough Surfaces

Effects of surface optical and radiative properties on the thermal performance of a solar cavity receiver

Principles in the design of surface temperature measurement method via radiation approach]