Disposal of Boron-Containing Wastwater by Lightly-Burnt Dolomite

Zun-li WEI,Yi-ying JIANG,An-huai LU,Zhen-ying LI,Yun-hua YAN,Chang-qiu WANG

DOI: https://doi.org/10.16461/j.cnki.1000-4734.2010.03.009

2010-01-01

Abstract:To dispose of boron-containing wastewater from a mine in Liaoning Province,China,the factors affecting both adsorption process and adsorption state of boron on lightly-burnt dolomite surface,combined with the adsorption mechanisms were thoroughly investigated.Over 90% of boron was removed under the optimal experimental conditions,i.e.2 g dolomite in size of 200 ～ 300 mesh after being heat-treated at 750℃ ,and reacted with 20 mL wastewater at pH 9.5 ～ 10.5 for 3 hours.The pH value determined the forms of boron compounds and the adsorption process.When pH was lower than 9.2,the adsorption of boron on lightly-burnt dolomite was not obvious.When pH was between 9.2 and 12 (the potential of zero charge of lightly-burnt dolomite) ,B(OH) 4-was adsorbed on the mineral surfaces by the outer complex mode.In terms of this process,the boron adsorption capacity was predominantly decided by the OHconcentration.When pH was higher than 12,the mineral surface was negatively charged,and there was no electrostatic adsorption.The analysis of X-ray photoelectron spectroscopy (XPS) and fourier transformation infrared spectra (FT-IR) indicated that boron was adsorbed on the surfaces of lightly-burnt dolomite with the complexing structure of BO4 tetrahedron.