Abstract:Anion exchange membrane water electrolysis is a potentially low-cost and sustainable technology for renewable-energy driven hydrogen production. Realisation of its full potential relies on the development of cost-effective, earth-abundant OER electrocatalysts alternatives to the state-of-the art noble metal oxides 1 . Ternary transition metal oxides, such as cobalt nickel oxides, are promising candidates due to their excellent alkali resistance in combination with remarkable catalytic activities. The latter relate to their tuneable oxidation states and variation in coordination of their metal centres. These correlations can be properly investigated when precise control over the layer chemical composition is attained. Atomic layer deposition (ALD) is widely acknowledged to deliver control over film uniformity, thickness and conformality, as well as film chemical composition due to the self-limiting nature of its surface reactions. In this study, an ALD supercycle process based on cobalt cyclopentadienyl (CoCp 2 ) and nickel methylcyclopentadienyl (Ni( Me Cp) 2 ) precursors and an oxygen plasma co-reactant has been developed 2 to investigate the influence of chemical composition and crystallographic properties of cobalt nickel oxide thin films on their electrocatalytic OER performance. Deposition of ~20 nm binary nickel oxide and cobalt oxide results in the growth of polycrystalline films of the rock-salt and spinel phase, respectively. Ternary cobalt nickel oxide films with various ratios can be deposited uniformly, as indicated by energy dispersive x-ray spectroscopy mapping. The mixed oxides display a transition from the +2 oxidation state-based pure rock-salt phase ( 75% at.% Co) upon increasing Co at.% as verified by electron diffraction (figure a) and x-ray photoelectron spectroscopy (XPS). XPS furthermore reveals a linear increase in the Ni 3+ -to-Ni 2+ ratio with increasing Co at.%, which indicates that an inverse spinel structure is formed. The formation of a Ni 3+ -rich inverse spinel cobalt nickel oxide between 55 and 75 at.% Co facilitates the formation of a semi-metallic state (10 2 S/cm) as opposed to the poorly conductive binary oxides (10 -3 S/cm and 10 -2 S/cm for NiO and Co 3 O 4 , respectively). Cyclic voltammetry (CV) measurements in 1M KOH, reveal chemical composition dependent activation behaviour (figure b). Continuous activation behaviour is observed for rock-salt phase films, whilst increment of the Co at.% results in reduced film activation until virtually no activation of the spinel phase films is observed. The activation of the nickel-rich film is accompanied by irreversible redox changes from the +2 to +3 oxidation state as indicated by the integrated non-catalytic wave. Post CV XPS analysis confirms the transition from Co 2+ and Ni 2+ oxidation states to Co 3+ and Ni 3+ . The formation of an (oxy)hydroxide state is observed for the rock-salt dominated films, whilst oxidation states characteristic of a spinel- like oxide structure are observed for the cobalt-rich films. No changes in the transition metal ratios are observed after activation. Scanning electron microscopy images furthermore reveal that the transformation of the Ni-rich films is accompanied by surface restructuring. These results indicate that initial composition can significantly influence the electrocatalytic performance of ternary oxides and therefore highlight the importance of techniques such as atomic layer deposition to study their complex behaviour. 1 Xu et al., Energy Chem., 4 (2022) 100087 2 van Limpt et al., J. Vac. Sci. Technol. A, 41 (2023) 032407 This work has been carried out within the SCALE project (NWA.1237.18.001) funded jointly by the Netherlands Organization for Scientific Research. Authors would like to thank the co-founders of the project ISPT, Syngaschem, VecoPrecision and Vsparticle and international partners Toyota Motor Europe and FORTH institute. Figure: (a) ALD deposited cobalt nickel oxide film show a transition from the +2 oxidation state-based rock-salt phase (NiO) to the spinel structure consisting of mixed +2/+3 oxidation states (Co 3 O 4 ) upon tuning the chemical composition as identified by electron diffraction. (b) This significantly affects the OER-electrocatalytic performance and activation of the films as represented by the current density at 1.8V vs RHE over 500 CV cycles in 1M KOH. Data labels indicate cobalt concentration as at.% Co/(at.% Co+ at.% Ni) . Figure 1

Deposition of Ni–Co by cyclic voltammetry method and its electrocatalytic properties for oxygen evolution reaction

Electrophoretic deposition of ZnCo2O4 spinel and its electrocatalytic properties for oxygen evolution reaction

Anodically Electrodeposited Co+Ni Mixed Oxide Electrode: Preparation and Electrocatalytic Activity for Oxygen Evolution in Alkaline Media

Electrodeposition and corrosion performance of Ni-Co alloys with different cobalt contents

Comparison of three preparation methods of NiCo2O4 electrodes

Electrodeposition of Ni–Co alloys from a deep eutectic solvent

Enhanced oxygen evolution reaction of electrodeposited Functionally-Graded Ni-Cu-Fe coating

Incorporation of Cu/Ni in Ordered Mesoporous Co-Based Spinels to Facilitate Oxygen Evolution and Reduction Reactions in Alkaline Media and Aprotic Li-O2 Batteries

Digital Composition Control of Cobalt Nickel Oxides by ALD for the Oxygen Evolution Reaction

High-entropy amorphous FeCoCrNi thin films with excellent electrocatalytic oxygen evolution reaction performance

Insight the Effect of Surface Co Cations on the Electrocatalytic Oxygen Evolution Properties of Cobaltite Spinels

Metal-oxygen bonding nanoarchitectonics for regulation of oxygen evolution reaction performance in FeNi-codoped CoOOH

Electrocatalytic activity for the hydrogen evolution of the electrodeposited Co–Ni–Mo, Co–Ni and Co–Mo alloy coatings

Co-Doped Ni3V2O8 Nanofibers Achieving d-d Orbital Coupling for Electrocatalytic Oxygen Reduction

Dynamic Investigations on CoFe2O4@Co3O4 Nano-composite as an Enhanced Electrocatalyst for Oxygen Evolution Reaction

In-situ Exsolution of CoNi Alloy Nanoparticles on LiFe0.8Co0.1Ni0.1O2 Parent: New Opportunity for Boosting Oxygen Evolution and Reduction Reaction

An efficient and stable MnCo@NiS catalyst for oxygen evolution reaction constructed by a step-by-step electrodeposition way

PdCoNi Alloy Nanoparticles Decorated, Nitrogen-Doped Carbon Nanotubes for Highly Active and Durable Oxygen Reduction Electrocatalysis

Ni–Fe Nanosheets Anchored on Porous Cobalt Substrate towards Oxygen Evolution Reaction

An advanced flower-like Co-Ni/PI-CNT film electrocatalyst for oxygen evolution reaction

Electrochemical behavior and electrodeposition of Fe-Co-Ni thin films in choline chloride/urea deep eutectic solvent