Abstract:The removal filter coefficients in this technique are dependent on the jammer’s power and its Instantaneous Frequency (IF) information, which can both be obtained in the time–frequency domain (adaptive filtering techniques). The dependence of the removing/reducing filter characteristics on the interference power is critical, as it allows an optimal trade-off between removal interference and the amount of self-noise generated by the filter. This trade-off is bounded by the two extreme cases of no notch filter (no self-noise) and full suppression (k1 = 1) for both low- and high-power jammer values. In this paper, a cascade second-order adaptive direct Infinite Impulse Response (IIR) Notch Filter (NF) with a gradient-based algorithm to suppress the Continuous-Wave (CW and MCW) interference is proposed for maximizing the receiver Signal-to-Noise Ratio (SNR) in a Quadrature Phase-Shift Keying (QPSK)-modulated signal. The suppression approach consists of two Adaptive IIR NFs (ANFs) based on a direct-form structure: the Hd1(z) and Hd1(z). The proposal in this work presents a low-complexity Time-Domain (TD) algorithm for controlling the update filter coefficient and notch depth. Simulation results demonstrate that the proposed approach represents an effective method for removing/reducing the impacts of CWI/MCWI, resulting in improved system performance for low- and high-power jammer values when compared with the case of full suppression (k1 = 1); furthermore, it also improves the notch filter’s output SNR for a given Jamming-to-Signal Ratio (JSR) value and Bit Error Ratio (BER) performance. For example, the SNR output of the proposed IIR NF was enhanced by 7 dB versus the case without a filter when Eb/No = 15 dB and JSR = −5 dB. The proposed method can detect and mitigate weak and strong jamming with JSR values ranging from −30 to 40 dB, and can track the hopping frequency interference. Moreover, an improved BER performance is seen as compared to the case without an IIR NF.

The Design of Adaptive Notch Filter Used in the Signal Processing of the Dithered RLG

Dither signal removal of ring laser gyro based on adaptive noise canceling

Design and Analysis of Robust Active Damping for LCL Filters Using Digital Notch Filters

An Improved Adaptive Lattice Notch Filter and Its Application

Research on Small Delay Signal Processor Method of Mechanical Dithered Ring Laser Gyro

A stable adaptive notch filter with optimal tracking properties

Recursive Least Squares-Like Algorithms for the Adaptive Second-Order Lattice Notch Filter

Research on New Signal Processing Method of Mechanically Dithered Ring Laser Gyro

An Iteration Algorithm Applied to Complex Adaptive Notch Filter with Constrained Poles and Zeros

A Variable Step-Size Adaptive IIR Notch Filter and Its Application in Reverberation Canceling

Design of Simple Integral Coefficient Notch Filter to Remove Power-line Interference in High Sampling Rate

Adaptive Notch Filter with Real Time Disturbance Frequency Control

A Novel Algorithm of Adaptive IIR Lattice Notch Filter and Performance Analysis

Single and Multiple Continuous-Wave Interference Suppression Using Adaptive IIR Notch Filters Based on Direct-Form Structure in a QPSK Communication System

Multiple Fully Adaptive Notch Filter Design Based on All-pass Filters

Design on Dynamic Acoustic Feedback Exterminators based on Multi-band FFT Algorithm

Design and performances analysis of multichannel adaptive notch filters

Pole-Zero Design Method of PowerFrequency for Eliminating Notch Filters

Howling Detection and Suppression Based on Segmented Notch Filtering

A New Design Of Prefilter For Reducing Timing Synchronization Jitter

A Novel Algorithm for Adaptive Notch Filter to Detect and Mitigate the CWI for GNSS Receivers