Abstract:In order to study the heat transfer of water during film boiling, stable film boiling heat transfer experiments are conducted in a circular tube. As the temperature of the heater surface sharply increases in a short period of time when critical heat flux (CHF) occurs, hot-patch technology is adopted to prevent damage to the test section. A complete experimental design, including the experimental facility, test section, experimental procedures, and the measurement of parameters, is developed. Two experimental schemes are used for testing, namely the post-CHF test and the quench test, respectively. These two schemes have been verified to achieve stable film boiling and yield consistent results. The effect of various parameters, including heat flux, pressure, mass flow and inlet subcooling, on the heat transfer coefficient has been analyzed. The experimental parameters range from an inlet subcooling of 10-50 K, a pressure of 0.1-2.5 MPa, and a mass flux of 100-1000kg/m2s. Through the analysis of the distribution of heat transfer coefficient along the axial location, three distinct heat transfer regions can be identified. Combined with heat transfer characteristics, three types of flow are considered: smooth inverted annular flow, rough inverted annular flow and inverted slug flow. Most of the data in this study is concentrated in the first two regions, namely the inversed annular flow. The data obtained in these tests is expected to provide important information for the study of inverted annular flow.

Experimental Investigations on Boiling Heat Transfer Inside Miniature Circular Tubes Immersed in FC-72

BOILING HEAT TRANSFER INSIDE MINIATURE CIRCULAR TUBES IMMERSED IN FC-72

BOILING HEAT TRANSFER OF FC-72 ON A VERTICAL SURFACE AND INSIDE MINIATURE TRIANGULAR CHANNELS

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Experimental and Numerical Studies on Enhanced Flow Boiling in Tube with Superwetting Micro-Finned Surfaces

Bubble Dynamics of Water Boiling Heat Transfer in Vertical Rectangular Mini-Channel

Study on Forced Convective Heat Transfer of FC-72 in Vertical Small Tubes

Experimental and Numerical Study of Jet Impingement Boiling Heat Transfer on Hot Tube Array

Experimental Design and Analysis for Film Boiling Heat Transfer in a Circular Tube

An Experimental Investigation of Single-Phase Heat Transfer in 0.045mm to 0.141mm Microtubes

Experimental Investigation of the Heat Transfer Characteristics of Liquid Nitrogen in the Capillary Tubes

FLOW BOILING CRITICAL HEAT FLUX IN A SMALL TUBE FOR FC-72

Experimental Study on the Heat Transfer Characteristics of Saturated Liquid Nitrogen Flow Boiling in Small-Diameter Horizontal Tubes

BOILING IN THE HORIZONTAL TUBES WITH THREE--DIMENSIONAL INNER MICROFIN

Experimental and Numerical Analysis of the Influence of Microchannel Size and Structure on Boiling Heat Transfer

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

EXPERIMENTAL STUDY OF LIQUID FLOW AND HEAT TRANSFER IN MICROTUBES

Experimental Study of Flow Boiling Heat Transfer in Mini-Tube

Experimental Study on Single- to Two-Phase Flow and Heat Transfer of Water in a Small Tube

Effect of the Size of Micro-Pin-Fin on Boiling Heat Transfer from Silicon Chips Immersed in FC-72.

Experimental Study of Boiling Phenomena of Liquid Nitrogen Around a Thin Wire Heater in Open Bath and Inside Capillary Tubes