Abstract:The present paper is dedicated to the development of a numerical model for the water impact of two-dimensional (2D) and axisymmetric bodies with imposed motion. The work is a first step towards the implementation of a 2D+t procedure to be used for the analysis of aircraft ditching. The problem is investigated under the assumptions of an inviscid and incompressible fluid, which is modelled by a potential flow model with fully non-linear boundary conditions at the free-surface. The unsteady boundary value problem with a free-surface is numerically solved through a boundary element method, coupled to a simplified finite element method to describe the thinnest part of the jet. The study is aimed at describing the entry and exit phases. Specific numerical solutions are developed to tackle the exit phase and to improve the stability of the model. Results are presented in terms of free-surface shape, pressure distribution and hydrodynamic load acting on the impacting body. The model is used to study the water entry and exit of a 2D wedge and an axisymmetric cone, for which numerical or experimental results are available in the literature. The numerical investigation shows that the proposed model accurately simulate both the entry and exit phases. For the exit phase, it is shown that the proposed model, being fully non-linear, provides a much better prediction of the loads and the wetted area compared to simplified (analytical) approaches. The effects of the gravity, usually missing in the approaches available in the literature, are also investigated, showing they are rather important, especially, in the exit phase.

Modeling and Simulation of Oblique Water-Entry of Disk Ogive

Numerical Simulation of Two-Dimensional Dam Failure and Free-Side Deformation Flow Studies

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Formulations of Hydrodynamic Force in the Transition Stage of the Water Entry of Linear Wedges with Constant and Varying Speeds

Numerical simulation of water entry using CIP model

A CIP-based Numerical Simulation of Wave Interaction with a Fluid-Filled Membrane Submerged Breakwater

A Numerical Study of Water Entry of Asymmetric Wedges Using a CIP-based Model

Numerical Study of Flat Plate Impact on Water Using a Compressible CIP–IBM–Based Model

Symmetrical and asymmetrical water entry of a three-dimensional bow-flared section by a Cartesian grid multiphase flow model with multiple DOF motion

Numerical analysis of cavity deformation of oblique water entry using a multi-resolution two-phase SPH method

Numerical Study of Violent Impact Flow Using a CIP-Based Model

Investigating the entry of symmetric/asymmetric elastic wedge into water

A Model for Water-Entry Projectile with an Open Cavity

Water entry and exit of 2D and axisymmetric bodies

Impact Load Characteristics of Large-Scale Trans-Medium Vehicles During High-Speed Oblique Water Entry

Numerical simulation investigation on water-entry cavity of high-speed spinning sphere

On Water-Entry Cavity Evolution Models and Maneuvering Motion of Supercavitating Vehicle

Numerical simulation for high speed oblique water entry of different density projectiles

Experimental Study and Numerical Simulation of the Water Entry of a Ship-Like Symmetry Section with an Obvious Bulbous Bow

Numerical Simulation of Water Entry of Wedges in Waves Using A CIP-Based Model