Abstract:The prediction of dynamic crushing behavior of aerospace-grade composites is a hard challenge for researchers. At coupons scale, such behavior implies the understanding of the initiation and propagation of the elementary damage mechanisms. Many results of the research confirm that the modulus and strength of composites increases with strain-rate. This paper presents the improvement of the constitutive model UL-Crush by adding dynamic stiffness modulus and strengths. The improved tool uses new approach by updating the stiffness and the strength values depending on strain-rates. In addition, parameter sensitivity investigations were conducted to assess the specific energy absorption capabilities of different material configurations. A new on-axis compression fixture was designed and manufactured to carry out tests of plain weave fabric composites, under quasi-static (QS) and low-velocity compression using MTS Insight 100 loading frame and drop tower CEAST Instron9340 facility. Two types of cross-section geometries were used: flat-plate and Hat-Shape coupons. Four types of triggering mechanism were adopted, including saw teeth, chamfer45°, steeple and corrugated, to ensure a continuous and stable crushing mode of failure. Detailed parameter sensitivity investigations were performed, including dimension scale, stacking sequences, trigger types and strain-rates. It was shown that the crush response is strain-rate dependent, and dynamic load decreases absorbed energy, which is indicative of microstructure disintegrating. Globally, big dimension scale, corrugated trigger, [0/45/45/0]s layup and decreasing strain-rate are the parameters to enhance the energy absorption capability of composite coupons. It has been observed that the improved numerical tool UL-Crush was able to significantly capture most crush mechanisms, reasonably correlate with experiments, and give an accurate dynamic response for crashworthy structures.

True Stress-strain Curves at Different Strain Rates Used in Vehicle Collision Simulation

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

A method of reverse and revision of material mechanics performance parameters for vehicle collision simulation

Investigations on the Johnson-Cook Constitutive and Damage-Fracture Model Parameters of a Q345C Steel

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Research on dynamic deformation behavior and constitutive relationship of hot forming high strength steel

Identification of Dynamic Constitutive Parameters of a High-Strength Steel and Numerical Simulation

Strain-Rates Dependent Constitutive Law for Crashworthiness and Parameter Sensitivity Analysis of Woven Composites

Effect of Material Anisotropy on the Mechanical Response of Automotive Steel under High Strain Rates

Characteristics of the Strain and Strain Rate on the Thin-Walled Square Tube Under Impact Loading

Test-and-FE-based method for obtaining complete stress-strain curves of structural steels including fracture

Identification of material parameters at high strain rates using ballistic impact tests and inverse finite element analysis

On the Constitutive Models for Ultra-High Strain Rate Deformation of Metals

Research on Dynamic Response and Fracture Properties of Metal Materials for Vehicle

Dynamic tensile behavior and constitutive model of a novel high-strength and high-toughness plate steel

A Dynamic Constitutive Model and Simulation of Braided CFRP under High-Speed Tensile Loading

Multi-stage Johnson–Cook Model for Collision Analysis: Impact Experiments and Simulations

A non-quadratic pressure-sensitive constitutive model under non-associated flow rule with anisotropic hardening: Modeling and validation

Constitutive Model for Full-Range Elasto-Plastic Behavior of Structural Steels with Yield Plateau: Formulation and Implementation

Large strain flow curve identification for sheet metals under complex stress states

Strain-Rate Effect and Constitutive Models for Q550 High-Strength Structural Steel