Study On The Improvement Of Steady State Steering Characteristic Of Vehcle
Chu Zhigang,Deng Zhaoxiang,Hu Yumei,Luo Hong
2006-01-01
Abstract:Based on the theory of Multibody dynamics, the dynamical virtual prototype of whole vehicle was established, including body, frame, steering assembly, front suspension assembly and pilot bar, rear suspension assembly and pilot bar, transmission assembly and so on, which is satisfied with the maneuvering performance and ride performance analysis. Based on the virtual prototype, the law of the steady state steering characteristic of vehicle influenced by the stiffness of the front screw spring and the diameter of the stabilizer anti-roll bar was discussed. By properly increasing the stiffness of the front screw spring and the diameter of the stabilizer anti-roll bar, the steady state steering characteristic of the vehicle had been improved greatly; but with the increasing of the stiffness, the increasing rate of the side acceleration at neutral steering point decreased rapidly. Further research presented: when the stiffness of the front screw spring increased from 30N/mm to 32.5N/mm and the diameter of the stabilizer anti-roll bar increased from 20mm to 21mm, the side acceleration at neutral steering point also increased from 5.32 m/s(2) to 6.18 m/s(2), the RMS value of total weighted acceleration of driver's seats increased from 0.6027 m/s(2) to 0.6268 m/s(2). The results of intergrated measure show that the steady state steering characteristic of vehicle improves greatly, but the effect on the riding performance is not evident.