Abstract:The development of new energy vehicles, particularly electric vehicles, is robust, with the power battery pack being a core component of the battery system, playing a vital role in the vehicle's range and safety. This study takes the battery pack of an electric vehicle as a subject, employing advanced three-dimensional modeling technology to conduct static and dynamic analyses. Through weight reduction and structural optimization, an innovative power battery pack design scheme is proposed, aiming to achieve a more efficient and lighter electric vehicle power system. The main research tasks are as follows: Firstly, we designed the main load-bearing components of a certain electric vehicle's power battery pack and established a three-dimensional (3D) model. Then, the model was simplified according to the actual stress conditions of the power battery pack of the electric vehicle and imported into finite element analysis (FEA) software. Next, based on the fundamental principles of the finite element method (FEM), we conducted static analyses under three conditions: bumpy road sharp left turn, bumpy road sharp right turn, and bumpy road emergency braking. The analysis results indicate that the strength of the battery pack meets the allowable requirements, suggesting that the lower housing design has significant redundancy, providing guidance for subsequent optimization. Finally, through modal analysis, we extracted the first six modes of the power battery box, with the first mode frequency being 33.69 Hz. This suggests that the battery pack may experience resonance during actual operation. Based on the static and modal analysis results, we proposed a structural optimization and lightweight design solution for a certain electric vehicle battery pack and compared it with the pre-optimization data.

Strength and modality analysis on structure of fuel cell vehicle subframe

Structural Analysis of Agricultural Truck Frame Based on the Finite Element Method

Parametric Finite Element Analysis for the Full-integral Bus Frame Based on NX

Finite Element Analysis and Light Weight Design of a Fuel Cell City Bus Structure

Finite Element Analysis and Structural Optimization Research of New Energy Vehicle Battery Box

Modal Analysis and Some Solutions to Front Sub-frame on a Car

Optimization and Structural Analysis of Automotive Battery Packs Using ANSYS

Analysis and optimization of the front subframe of vehicle

Modal analysis and improvement of the frame for all-terrain vehicle

Finite element modeling of electric vehicle power battery pack and its influence analysis and test research at body-in-white stage

Finite Element Analysis and Structural Improvement on Jaw Crusher Frame with Compound Pendulum

Vehicle Structural Design and Analysis in Maglev Experimental Line

Optimized Design of Inadequate Stiffness of Radiator Frame inside Engine Room on a Specific Vehicle

Frontal crashworthiness structure analysis and optimization of electric vehicle

Finite Element Analysis on the Rear Axle Housing of Vehicle

Design and Performance Analysis of Multi-axle Independent-drive Heavy-duty Fuel Cell Vehicles

The Statics and Modal Analysis of the Fuel Batteries Engine Main Frame Based on FEM

Optimized Lightweight Frame for Intelligent New-energy Vehicles

Stress Relaxation of a Sport Utility Vehicle Chassis Using a Dynamic Force Counteracting Approach

Design and Analysis of Battery Bracket Structures for Different Vehicles

Finite Element Analysis and Structure Design for Chassis of Aircraft Towbarless Tractor