Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Influence of Copper Precursors on the Structure Evolution and Catalytic Performance of Cu/HMS Catalysts in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Advances in copper-based catalyst for the methanol synthesis from CO2 hydrogenation

The Nature of Active Copper Species in Cu-HMS Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol: New Insights on the Synergetic Effect Between Cu0 and Cu+

Highly Active and Selective Copper-Containing Hms Catalyst in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Ion‐Exchange Temperature Effect on Cu/HMS Catalysts for the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Novel Highly Efficient Cu/Hms Catalyst and Its Application to the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Selective Hydrogenation of Dimethyl Maleate to Tetrahydrofuran over Cu/SiO2 Catalyst: Effect of Cu+ on the Catalytic Performance

Role of Copper Content and Calcination Temperature in the Structural Evolution and Catalytic Performance of Cu/P25 Catalysts in the Selective Hydrogenation of Dimethyl Oxalate

Effect of Initial Precipitation Temperature on the Structural Evolution and Catalytic Behavior of Cu/SiO2 Catalyst in the Hydrogenation of Dimethyloxalate

The Influence of Copper Particle Dispersion in Cu/SiO 2 Catalysts on the Hydrogenation Synthesis of Ethylene Glycol

Investigation of the Structural Evolution and Catalytic Performance of the Cuznal Catalysts in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Efficient Tuning of Surface Copper Species of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

One Pot Synthesis of Ultra-High Copper Contented Cu/Sba-15 Material As Excellent Catalyst in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of Si/Al Ratio of Mesoporous Support on the Structure Evolution and Catalytic Performance of the Cu/Al-HMS Catalyst

Cu/SiO2 Catalysts Prepared by the Ammonia-Evaporation Method: Texture, Structure, and Catalytic Performance in Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

The Influence of B-doping on the Catalytic Performance of Cu/HMS Catalyst for the Hydrogenation of Dimethyloxalate

Copper-based catalysts synthesized during hydrogenation

Investigation of Activated‐Carbon‐Supported Copper Catalysts with Unique Catalytic Performance in the Hydrogenation of Dimethyl Oxalate to Methyl Glycolate

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Copper phyllosilicate-derived ultrafine copper nanoparticles with plenty of Cu<SUP>0</SUP> and Cu<SUP>+</SUP> for the enhanced catalytic performance of ethylene carbonate hydrogenation to methanol

Effect of the Hydrogenation Components on Copper-Based Catalysts for Synthesis of Dimethyl Ether from CO2 Hydrogenation