Abstract:It is crucial to identify the battery's internal short circuit (ISC) for safety. The study aims to explore the effectiveness of ISC detection methods through battery aging. Two types of method are compared in this work: diffusion coefficient calculation based on electrochemical impedance spectroscopy and conventional internal resistance monitoring through algorithms such as recursive least square (RLS). In this work, the frequency-domain P2D model is built to simulate the behavior of the impedance response with different levels of ISC. Then, coin cells are assembled with conductive contaminants to examine the accuracy of the model simulation and the actual influences of the ISC on the impedance. Afterwards, with the proven impedance model and potential influences, the substituted ISC test on commercial 18,650 cells is applied to examine ISC detection based on EIS under different aging statuses. Finally, the conventional internal resistance identification method is used for comparison. The coin cell experimental results in the study indicate that the inception of the ISC mainly alters the low-frequency impedance with much reduced phases, which is also predicted by the model simulation. Similar results with the impacted low-frequency impedance can also be observed in the substituted ISC test for the commercial cells. The diffusion coefficients, the parameter mainly associated with the low-frequency impedance response, increased by 47–143 % as the battery SOH decreased from 100 % to 87 %. In comparison, the internal resistance identification method indicates that the ohmic component is relatively stable after the inception of the ISC. The polarization component of the internal resistance exhibits a significant change as high as 234 %. However, as the battery's SOH decreases, the effectiveness of the polarization resistance fades toward 23 %.

Ohm Internal Resistance Test for Power Battery

Measurement of Thermophysical Parameters and Thermal Modeling of 21,700 Cylindrical Battery

Effects of Depth-of-Discharge, Ambient Temperature, and Aging on the Internal Resistance of Lithium-Ion Battery Cell

State of Charge and Lithium Manganate Batteries Internal Resistance Estimation at Low Charge/discharge rates

Vrla Battery Internal Resistance On-Line Measurement Based On Digital Phase Sensitive Detection

An Internal Resistance Estimation Method of Lithium-Ion Batteries with Constant Current Tests Considering Thermal Effect.

Analysis of Li-Ion Battery Cell Internal Impedance Changes Based on Temperature and Soh

Investigation and comparison of the electrochemical impedance spectroscopy and internal resistance indicators for early-stage internal short circuit detection through battery aging

Online estimation method for battery capacity loss

Online Internal Resistance Measurement Application in Lithium Ion Battery Capacity and State of Charge Estimation

Effects of temperature on the ohmic internal resistance and energy loss of Lithium-ion batteries under millisecond pulse discharge

Realization of Internal Resistance Measurement of Lithium Battery with Auto Calibration Technology

Design of On-line Testing for Battery Internal Resistance and Spectrum Analyzer

On-line Measurement of Internal Resistance of Lithium Ion Battery for EV and Its Application Research

Analysis of Open Circuit Voltage and Internal Degradation under External Factors for EV Battery Considering Hysteresis

An Aging- and Load-Insensitive Method for Quantitatively Detecting the Battery Internal-Short-circuit Resistance

Effect of Internal Resistance on Consistency in a Set of Batteries at Low Temperature

Impact of Internal Resistance on the Consistency of Lithium Ion Energy Storage Batteries

Degradation Diagnosis of Lithium-Ion Batteries Considering Internal Gas Evolution

Electric Vehicle Li-Ion Battery Evaluation Based on Internal Resistance Analysis

Estimation the internal resistance of lithium-ion-battery using a multi-factor dynamic internal resistance model with an error compensation strategy