Abstract:The new developed metal/composite co-cured material composed of carbon fiber–reinforced plastic and Al phases has been increasingly applied for manufacturing of attitude control flywheel in aerospace industry. However, drilling of co-cured material is still a challenging task to produce holes with high quality and low cost in the assembly chain and dynamic balance debugging of attitude control flywheel. In other words, the relevant mechanisms and experimental findings involved in the drilling process of carbon fiber–reinforced plastic/Al co-cured material is not clearly defined, which impedes the progress of attitude control flywheel production. To this end, this article specially addresses the experimental studies on the drilling process of carbon fiber–reinforced plastic/Al co-cured material with standard TiAlN-coated cemented carbide twist drill. The significance of this work aims to reveal the regardful cutting responses of the hole characteristics and tool wear modes during the practical drilling process of co-cured material. A full factorial experiment including three levels of feed rate and four levels of cutting speed was performed. The hole diameter shows different values in different positions while it indicates consistent pattern regardless of the cutting variables: the largest in the Al phase, followed by the upper and lower carbon fiber–reinforced plastic phases, respectively. Grooves and matrix degradation are the major machining defects for carbon fiber–reinforced plastic layers, while a great chip debris adhered to the machined surface is the case for Al layer. Subsequent wear analysis showed that abrasion was mainly maintained at the vicinity of major/minor cutting edges and drill edge corner, followed by chip adhesion on the chisel edge region. Carbide substrate of drill flank face is exposed, and thereafter cavities are formed under the strong mechanical abrasion. These results could provide several implications for industrial manufacturers during the attitude control flywheel production.

A New Type of Non-Chisel-Edge Shallow-Drill for Machining High Manganese Steel

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Development of a New Micro Drilling Tool with H-Shaped Chisel Edge

A Novel Design Method for Chip Flute of Indexable Insert Drill Used at Large Drilling Depth

A Newly Designed High-Strength Tool Steel with High Wear and Corrosion Resistance

Effect of high-speed steel screw drill geometry on cutting performance when machining austenitic stainless steel

Enhancement Of Kirschner Wire For Bone Drilling

Investigation on the Cutting Performance of a New Kind of Nickel-Based Super Alloy

Development of a BDD end-grinding-milling tool with dual-negative rake angle

Development of a hardbanding material for drill pipes based on high-manganese steel reinforced with complex carbides

Research on Deep-Hole Drilling of High-Strength Steel Using Slender Gun Drill

Wear behavior and machining quality of novel high-sharp brazed diamond abrasive core drills during drilling SiCf/SiC composite micro-holes

Investigations on the edge-chipping reduction in rotary ultrasonic machining using a conical drill

Hole quality and tool wear when dry drilling of a new developed metal/composite co-cured material

Exploring novel PVD coated wiper inserts' chip breaker designs and feed rates on tool wear and in-depth hole integrity of Ti-6Al-4V alloy when drilling in a dry environment

Study on tool wear in longitudinal-torsional composite ultrasonic vibration–assisted drilling of Ti-6Al-4V alloy

Enhancing Wear Resistance and Cutting Performance of a Long-Life Micro-Groove Tool in Turning AISI 201

Enhancement of Deep Drilling for Stainless Steels by Nano-Lubricant through Twist Drill Bits

Performance of High-Speed Steel Drills in Wet Drilling Inconel 718 Superalloy

Machining performance evaluation and tool wear analysis of dry cutting austenitic stainless steel with variable-length restricted contact tools

Hole-Making in D2-Grade Steel Tool by Electric-Discharge Machining through Non-Conventional Electrodes