Abstract:Thermal shrinkage has for long been a critical issue in nonwoven industrial applications. A dimensionally stable nonwoven web with excellent mechanical property was achieved by heat treatment with tension [taut annealed (TA)] instead of annealing under free state [free annealed (FA)], while the original high porosity was not affected. To better understand the fundamental structure-property relationship, these two different heat treatments' effects on the thermal behaviors, morphology, and phase structures of poly(phenylene sulfide) (PPS) nonwovens were elucidated via a combination of different experimental techniques such as temperature-modulated differential scanning calorimetry (DSC), two-dimensional wide-angle X-ray diffraction, two-dimensional small-angle X-ray scattering, and polarized Raman spectroscopy. It is evidenced that no obvious online stress-induced crystallization occurs during the melt-blowing process, making virgin PPS fibers mostly in the amorphous state. However, experimental results confirm that a certain amount of mesophase or constrained amorphous exists in the virgin PPS fibers without any presence of crystallites. After annealing, the DSC melting curves of both TA and FA PPS nonwovens exhibit endothermic annealing peaks, the origin of which is interpreted as the relaxation and devitrification of the rigid amorphous phase. However, the annealing peak position of the FA sample is always higher than that of the TA sample, which is reported for the first time. As compared with the FA sample annealed at the same temperature, TA PPS nonwovens reveal lower crystallinity and slightly larger lamellar long period (L-p) but a higher level of macroscopic fiber alignment and molecular chain orientation. These morphology and microstructure differences provide a good explanation for the superior mechanical property of TA PPS nonwovens with higher elastic modulus and tensile strength. The results are helpful in deepening the understanding of essential physical pictures of PPS nonwovens and promoting the development of the high-temperature nonwoven industry.

Effect of Annealing Treatment on Meta-poly(arylene sulfide sulfone amide)

Thermal Degradation of Poly(arylene Sulfide Sulfone)/ N -Methylpyrrolidone Crystal Solvate

Polymorphic Crystals from Different Thermal Treatments and Its Effect on Biodegradation Behavior of Poly(butylene Adipate)

Effect of Initial Molecular Weight on the Structural Evolution of Polyamide 1012 during High-Temperature Thermal Treatments as Revealed by Successive Self-Nucleation and Annealing

Influence of Annealing Temperature on the Lamellar and Connecting Bridge Structure of Stretched Polypropylene Microporous Membrane

Effect of Thermal Annealing on Conformation of MEH-PPV Chains in Polymer Matrix: Coexistence of H- and J-Aggregates

Influence of Syndiotacticity and Annealing Temperature on the Double Melting Peak Behaviour of Syndiotactic Polypropylene

INFLUENCE OF THERMAL TREATMENT ON CRYSTAL MELTING BEHAVIOR AND CRYSTAL STRUCTURE OF NYLON 6 AND POLYAMIDE BLOCK COPOLYMER/NYLON 6 BLENDS

The Influence of Processing Aids on the Properties of Poly (arylene Sulfide Sulfone)

Annealing Of P3ht:Pcbm Blend Film-The Effect On Its Optical Properties

Influence Of Annealing On Chain Entanglement And Molecular Dynamics In Weak Dynamic Asymmetry Polymer Blends

Effect of annealing on phase structure and mechanical behaviors of polypropylene hard elastic films

Heat-setting Effect on the Morphology and Phase Structures of PPS Nonwovens

An Investigation Of Cure And Thermal Stability Of Poly(Amide-Amidic Acid) Modified Tetraglycidyl 4,4-Diaminodiphenylmethane/4,4-Diaminodiphenylsulfone

Effect of annealing on the microphase separated behavior and properties of PDMS–MDI–PEG multiblock copolymer films

Study of the effect of annealing process on the performance of P3HT/PCBM photovoltaic devices using scanning-probe microscopy

Effect of thermal annealing on gas separation performance and aggregation structures of block polyimide membranes

Impact of Thermal Annealing on the Dissolution of Semiconducting Polymer Thin Films

Quantitative Nanoscale Monitoring the Effect of Annealing Process on the Morphology and Optical Properties of Poly(3-Hexylthiophene)/[6,6]-phenyl C61-butyric Acid Methyl Ester Thin Film Used in Photovoltaic Devices

Annealing Effect on Chain Segment Motion and Charge Detrapping in Polyamide 610

Probing Into the Annealing Effects on Microstructure and Mechanical Properties of Impact Polypropylene Copolymer With Nodular Crystalline Morphology