Abstract:We report a temperature measurement method based on fixed wavelength transmission intensity of long-period fiber grating. Relative to wavelength or edge filtering, this method has obvious advantages in measurement accuracy and cost. The relationship between the transmission intensity and temperature at a fixed wavelength is simulated based on the theory of long-period fiber grating coupling mode. The results show that the transmission intensity of the fixed wavelength is linearly related to the temperature with the appropriate parameters. In the experiment, the transmission spectrum shows two resonant peaks at 1485 and 1538 nm. Two fixed wavelengths at 1480.4 and 1549.7 nm were selected, and the results show a linear relationship between transmission intensity and temperature. The temperature sensitivity of the transmission intensity at 1480.4 nm is about 0.0544 dB / ° C, which means the value of I1480.4 nm / I0 changes by 1.3% for every 1°C. To eliminate the influence of light source and enhance the measurement sensitivity, the ratio of the transmission intensity of two fixed wavelengths was selected to carry out the temperature measurement. The temperature sensitivity of the ratio of I1480.4 nm / I1549.7 nm was 0.0729 dB / ° C, that is, the light intensity ratio changed by 1.7% when the temperature changed by 1°C. A more reasonable design of long-period fiber grating and a more appropriate selection of fixed wavelength should be able to obtain higher temperature sensitivity.

Numerical Comparison on the Measurement Time of Long Range Fiber Raman Distributed Temperature Sensors Operating at 1.66 Μm and 1.55 Μm

Fiber Raman Distributed Temperature Sensor Based on the Light Source with Adjustable Pulsewidth

Design of data acquisition system for distributed optical fiber sensor

Enhanced Raman Distributed Temperature Sensor Using a High Raman Gain Fiber

Measurement of radiation temperature with high time-resolution

Improving Spatial Resolution in Fiber Raman Distributed Temperature Sensor by Using Deconvolution Algorithm

Research of Distributed Optical Fiber Temperature Measurement System Based on Raman Scattering Principle

Distributed Optical Fiber Sensing Measurement Based on Time Offset

Fiber temperature sensor based on rare earth fluorescence material

Raman-based Distributed Temperature Sensor Using a 1.66μm Ring Type Q-switched Fiber Laser with Adjustable Pulsewidth

Comparison of Measurements with Finite-Element Analysis of Silicon-Diaphragm-Based Fiber-Optic Fabry–Perot Temperature Sensors

High-Precision Fiber Noise Detection and Comparison over a 260 km Field Fiber Link

Simultaneous Measurement of Refractive Index and Temperature Using a Mach-Zehnder Interferometer with Forward Core-Cladding-core Recoupling

Distributed fiber optic temperature sensor based on dynamic calibration of Raman Stokes backscattering light intensity

Method of Fiber Transfer Delay Measurement Based on Phase Quantization and Delay Synthesis

Performance evaluation of Raman scattering-based distributed optical fiber temperature sensing system in cryogenic environment

24 km High-Performance Raman Distributed Temperature Sensing Using Low Water Peak Fiber and Optimized Denoising Neural Network

Method for temperature measurement of taper long-period fiber Bragg grating

Design and Implementation of Temperature Measurement System Based on Distributed Fiber Grating Sensor

The Research on Improving the Spatial Resolution of Radiant Optical Fiber Temperature Sensor

Optical Frequency Transfer over 60 km Urban Telecom Fiber Link