Abstract:Ferromagnetic 'Ti/Fe- and/or Co-containing TiO 2 -layer' composites formed by plasma electrolytic oxidation (PEO) in electrolytes with dispersed particles of iron and/or cobalt hydroxides exhibited photocatalytic activity in methyl orange (MO) degradation under UV and visible light in the presence of hydrogen peroxide. The influence of Fe/Co ratio and additional annealing was studied on their chemical composition, optical, photocatalytic, and adhesion properties. With the proportion of cobalt in the coatings, their adhesion to titanium increased. After annealing, coatings with a higher proportion of iron had higher adhesion. The optical band gap energy E g determined for direct allowed transitions was 1.37 eV and 1.61 eV for individual Fe-containing and Co-containing composites, respectively. In mixed Fe- and Co-containing PEO-composites, two direct allowed transitions were detected with E g1 =1.68 eV and E g2 =2.21-2.54 eV. Among initial PEO-coated samples, the most active and stable are Fe- and Co-containing PEO layers with a predominance of cobalt: MO degradation under 3-h irradiation with UV and visible light was 64 and 21%, respectively. According to X-ray photoelectron spectroscopy, their surface layers contain a higher percentage of Fe 2+ and Co 2+ compared to Fe 3+ and Co 3+ . Annealing the samples in air led to an increase in E g values and a leveling off of photocatalytic activity as a result of the formation of crystalline NaTi 2 (PO 4 ) 3 , FePO 4 , or CoPO 4 phases and an increase in the proportion of oxidized iron. The main role in the degradation of MO was found to be played by hydroxyl radicals formed as a result of the interaction of hydrogen peroxide with photogenerated electrons.

Co-deposition of Photocatalytic Fe Doped TiO2 Coatings by MOCVD

One Step Preparation of Visible-Light Responsive Fe–TiO2 Coating Photocatalysts by MOCVD

Influence of Fe2o3 Doping on Morphology and Photocatalytic Activity of Tio2 Prepared by Adsorption Phase Synthesis

Preparation of Photocatalytic Fe2O3–TiO2 Coatings in One Step by Metal Organic Chemical Vapor Deposition

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Co-Modified Commercial P25 Tio2 by Fe Doping and G-C3n4 Coating As High Performance Photocatalyst under Visible Light Irradiation

Preparation and Photocatalytic Properties of Fe(III)-Grafted TiO<sub>2</sub> Nano-Composite Powders

Improvement Of The Photocatalytic Properties Of Tio2 By (Fe+Mo) Co-Doping-A Possible Way To Retard The Recombination Process

Enhanced visible light photocatalytic activity of Fe2O3 modified TiO2 prepared by atomic layer deposition

Photo-Catalytic Activity of Fe3+/Sn4+Co-Doped Titanium Dioxide Nano-Crystalline Thin Films for Methyl Orange Degradation

Photo-catalytic activity of Fe3+/Sn4+ co-doped titanium dioxide nano-crystalline thin films for methyl orange degradation

Preparation and Enhanced UV Visible Light Photoelectrocatalytic Activity of TiO2 Fe2O3/Cu Ternary Nanocomposites

Ferromagnetic PEO coatings on titanium as photo-Fenton-like heterogeneous catalysts

Effect of Fe doping on crystalline phase, structure and photocatalytic properties of TiO2 thin films

F and Fe co-doped TiO<sub>2</sub> with enhanced visible light photocatalytic activity

Preparation of FeOOH/TiO2 Composite Film by Photoelectric Deposition Method and Its Application in Photocatalysis

F and Fe co-doped TiO 2 with enhanced visible light photocatalytic activity

Structural phase transformation and photocatalytic activity of CoFe2O4-doped TiO2 nanopowders

Boosted Visible-Light Photodegradation of Methylene Blue by V and Co Co-Doped TiO₂

Visible-light-driven Oxygen Vacancies and Ti3+ Co-Doped TiO2 Coatings Prepared by Mechanical Coating and Carbon Reduction

Preparation of an Ag–TiO2 photocatalyst coated on activated carbon by MOCVD