Abstract:This paper presents an in-depth analysis of the oscillation phenomenon occurring in multi-chip parallel automotive-grade power modules under short-circuit conditions and investigates three suppression methods. We tested and analyzed two commercial automotive-grade power modules, one containing two chips and the other containing a single chip, and found that short-circuit gate oscillations were more likely to occur in multi-chip parallel packaged modules than in single-chip packaged modules. Through experimental and simulation analyses, we observed that gate oscillations were mainly caused by the interaction between internal parasitic parameters of the module and the external drive circuit, and we found that high drive resistance and low common emitter inductance between parallel chips could effectively suppress gate voltage oscillations. We also analyzed the two mainstream suppression schemes, increasing the drive gate resistance and placing the drive capacitors in parallel. Unfortunately, we found that these suppression schemes were not ideal solutions because both schemes changed the switching characteristics of the power module. As an alternative, we propose a simple and effective solution that involves adding parallel connections between the parallel chips. Simulation calculations showed that this optimized method reduced the emitter inductance between parallel chips in the upper bridge arm by about 30% and in the lower bridge arm by 35%. Through short-circuit experiments conducted at different DC bus voltages, it has been verified that the new optimized solution effectively resolves gate oscillation issues without affecting the switching characteristics of the power module.

Analysis and Suppression of Inductive Interference in Active Integrated Power Electronics Module

Optimized Electrical Design for Single Phase Pfc Active Ipem

Design of Low Parasitic Inductance SiC MOSFETs Halfbridge Power Modules

Analysis of Electromagnetic Coupling in Hybrid Integrated Power Electronic Module

Turn-on Oscillation Damping for Hybrid IGBT Modules

Practical design considerations for IPEM-based PFC converter employing CoolMOS and SiC diode

Suppressing Methods of Parasitic Capacitance Caused Interference in a SiC MOSFET Integrated Power Module

An Advanced Design of Power Module with EMI Reduction Method

An Improved Power-Decoupling Scheme with Grid Inductor Phase-Shift Modification for Single-Phase Converter

Analysis of Gate Signal Interference in an Integrated SiC MOSFET Module

Integration of Both EMI Filter and Boost Inductor for 1-Kw PFC Converter

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Innovative Reverse Current Coupling Layout of SiC Power Module for Parasitic Inductance Reduction

Analysis and Optimization of High-Frequency Switching Oscillation Conducted CM Current Considering Parasitic Parameters Based on a Half-Bridge Power Module

Analysis and Suppression of Common-mode EMI Using Synchronous Pulsed Compensation in Power Electronics

Common-Mode EMI Mathematical Modeling Based on Inductive Coupling Theory in a Power Module With Parallel-Connected SiC MOSFETs

A Gallium Nitride Integrated Power Module with Ultra-low Parasitic Inductances and Thermal Resistance

Analysis of A Low-Inductance Packaging Layout for Full-Sic Power Module Embedding Split Damping

The Mechanism of Short-Circuit Oscillations in Automotive-Grade Multi-Chip Parallel Power Modules and an Effective Mitigation Approach

Electromagnetic Coupling Between Power Distribution Network and On-chip Inductors in Package

Decentralized Suppression Strategy of Circulating Currents among IPOP Single-Phase DC/AC Converters