Abstract:The influence of coating thickness on laser-induced damage (LID) characteristics of anti-reflection (AR) coatings irradiated by 1064 nm nanosecond laser pulses was investigated. Two HfO2/SiO2 AR coatings with different physical thicknesses, 0.7 and 2.7 mu m, were prepared and tested. To study the effect of coating thickness on a laser-induced damage threshold (LIDT) in isolation, electric field intensities (EFIs) at the substrate-coating interface were kept the same by using proper AR designs. Moreover, 2 nm artificial gold particles with a density of 10 mm(-2) were implanted into the substrate-coating interface to achieve reliable experimental results. An optical microscope (OM) and a scanning electron microscope (SEM) were used for an online LIDT test and offline LID morphology observation, respectively. The typical LID morphology of thicker AR coatings was flat bottom craters with diameters of 20-50 mu m, which can be easily observed by an online OM. For thinner AR coatings, hemispherical craters with diameters down to 1 mu m were found as typical LID morphology by a SEM. However, these tiny craters could not be observed by an online OM. Moreover, such tiny craters did not grow with subsequent pulses, so they did not degrade the functional laser damage resistance of the thin AR coatings. When identified with an online OM, the LIDT of thinner AR coatings is found to be about two times higher than the thicker ones, and large delamination was mainly found as the LID morphology of AR coatings with high fluence. When observed with a SEM, the LIDT of thin AR coatings with tiny craters was over 60% lower than the LIDT of thick AR coatings, which agrees with the model that less energy is required to form smaller LID craters of thinner coatings. (C) 2017 Optical Society of America

The Measurement and Analysis of Millisecond Laser Induced Damage of Two Kinds of Classical Coating Components

Researches on Laser Damage Resistance of Optical Films

Analysis and Comparison of Coating Damage Induced by Laser at 1ms and 10ns Pulse-Widths

Study on millisecond and nanosecond laser-induced damage of T iO 2/S iO 2 anti-reflectors

Effect of multi-waveband antireflective coating on laser induced damage threshold of MgO doped LiNbO3

Damage Performance of TiO2/SiO2 Thin Film Components Induced by a Long-Pulsed Laser

Femtosecond Laser-Induced Damage and Ultrafast Dynamics in Highs Reflection Coating

Investigation of the High Repetition Rate Picosecond Laser Induced Damage Properties of Dielectric Reflective Optical Coatings

Temperature Field Analysis of Optical Coatings Induced by Millisecond and Nanosecond Lasers

Investigation on Nano-Absorbing Precursors in the Picosecond Regime Via the Comparative Study of HfO2/SiO2 and Ta2O5/SiO2 High-Reflectivity Coating Damage

Study of Laser Induced Damage of High Reflector at 1064 Nm

High-repetition Rate Picosecond Laser-Induced Damage Properties of Ta2O5:SiO2 Coatings

The Fatigue Effect of Femtosecond Laser-Induced Damage in High-Reflective Coatings at Low Repetition Rate

Accumulation Effect of Multi-shot Laser-induced Damage to Optical Coatings

Characterization of Laser Induced Damage of HR Coatings with Picosecond Pulses

Femtosecond Laser Pulse Induced Damage In Thin Films - Art. No. 60281d

Investigating the material properties of HfO2/SiO2-based anti-reflection coatings during 1064 nm laser-induced breakdown in air and vacuum conditions

Investigation of damage induced by high-power continuous wave laser on SiC-based film

Surface Damage Performance Experiment of TiO2/SiO2 Thin Tilm by Pulsed Laser Induced

Temporal Scaling Law and Intrinsic Characteristic of Laser Induced Damage on the Dielectric Coating

Influence of Coating Thickness on Laser-Induced Damage Characteristics of Anti-Reflection Coatings Irradiated by 1064 Nm Nanosecond Laser Pulses