Abstract:Adding limestone to coal combustion reduces SO2 emissions but sometimes increases NO emissions, posing a challenge for synergistic SO2 and NO control in circulating fluidized bed (CFB) boilers. Limestone in the CFB furnace can participate in the conversion of sulfur and nitrogen compounds from coal and its devolatilized coke. This study compared the effects of limestone on SO2 and NO emission characteristics during coal/coke combustion to explore the potential for controlling both emissions. Combustion experiments were conducted in a fixed-bed reactor under different reaction parameters including Ca/S mole ratio, oxygen concentration, and temperature. Results showed that SO2 emissions decreased and NO emissions increased with increasing Ca/S mole ratio for both fuels. Comparing the emissions from fuels with and without limestone addition, a lower oxygen concentration decreased the desulfurization efficiency and the increment of NO emissions caused by limestone for both fuels. Temperature had opposite effects of limestone on coal or coke combustion. For coke, higher temperatures improved desulfurization efficiency and decreased the increment of NO emissions caused by limestone. For coal, the effects were reversed. To explain the impact of temperature, the sulfur and nitrogen migration paths affected by limestone were analyzed based on the XPS results of the fuels. Thiophene-S and N-Q became the main sulfur and nitrogen components in coke at high temperatures. The conversion of thiophene-S into SO2 is slow, and the limestone is calcined more fully during coke combustion, improving the utilization rate of limestone. N-Q tends to be converted into NH3. Further, NO is reduced by NH3 over the catalyze of CaO at low oxygen conditions. This reaction process decreases the increment of NO emissions caused by limestone.

Characteristic Study of Limestone on Aggklomeration of Fluidized Bed Incinerator

Agglomeration characteristics in fluidized bed incineration of organic-condensed wastewater

Model on desulfurization characteristic of limestone particles

Experimental Study on Calcination and Fragmentation Characteristics of Limestone in Fluidized Bed

Attrition Performance and Morphology of Limestone under Different Conditions in Fluidized Bed

Limestone Attrition and Product Layer Development During Fluidized Bed Sulfation

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Attrition of limestone during fluidized bed calcination and sulfation

Insights into the Desulfurization Mechanism of Low-Grade Limestone As Absorbent Induced by Particle Size

Emission characteristics of sludge incineration in bubbling fluidized bed

The Effect Of Limestone With Additive On Coal Combustion

Influence of Limestone Fillers on Combustion Characteristics of Asphalt Mortar for Pavements

Study on the Melting Characteristics of Slag from the Incinerator of Hazardous Wastes Containing Fluorine and Chlorine

Effects of Microstructure Characteristics on Limestone Reactivity in Wet FGD Process

Dissolution Reactivity and Kinetics of Low-Grade Limestone for Wet Flue Gas Desulfurization

A Study of the Explosive Cracking and Wear Characteristics of Limestone

Experimental study on the effect of limestone on SO2 and NO emission characteristics during coal/coke combustion

An Experimental Study on the Primary Fragmentation and Attrition of Limestones in a Fluidized Bed

Characteristics and mechanism of slagging in a 500 t/d MSW incinerator

Study on Influence Factors of Reactivity of Limestone in Limestone/Gypsum Wet FGD System

Experimental Study on Additive Enhanced Limestone Wet Flue Gas Desulfurization