Abstract:The paper addresses the method for stator and rotor resistance identification in speed sensorless induction motor drives. The instability problem caused by pure integration of the voltage model (VM) of rotor flux is handled by introducing correction terms in the VM. It is, however, shown that the third-order persistent excitation (PE) condition for simultaneous identification of stator, rotor resistances and rotor speed can barely be satisfied even with extra excitations in rotor flux modulus command. And an adaptive observer that is not persistently excited may become instable when exposed to bounded disturbances. Hence, to design a robust flux observer, concept of time-division multiplexing is incorporated into the observer design. That is, stator resistance is identified as the flux modulus is flat, while rotor resistance is adapted as a ramp flux modulus command is applied. This relaxes PE condition to order two, and as a drawback, the ramp flux modulus command incurs speed ripples. The decoupled identifiability of stator resistance is designed and explained, a rigorous input-to-state stability analysis of both the mismatch [between VM and current model (CM)] and the error (between actual rotor flux and CM) is set forth, and a convergence analysis of parameters is elaborated. To validate the feasibility, simulation and experiment results are included in the text as well.

Research on Stabilization of Induction Motor Speed Sensorless Control System in Low Speed Regenerating Mode

Stabilizing Method of Speed Adaptive Flux Observer for Speed Sensorless Induction Motor Drives

Study of Stability in Low Speed Regenerating Mode of Sensorless Vector Control of Induction Motor

Low Speed Stability Research of Adaptive Full-order Observer for Induction Motor

Speed-sensorless Direct Torque Control System of Induction Motor

An Adaptive Observer Design for Sensorless Control of Induction Motors

Feedback linearization control research of speed sensorless permanent magnet synchronous motor

A New Reactive Power-Based Sensorless Control Strategy For Five-Phase Induction Motor With Non-Sinusoidal Power Supply

Backstepping Control of Speed for Sensorless Permanent Magnet Synchronous Motor

Extremely Low Speed Performance Research of the Speed Sensorless Vector Controlled Induction Motor Drive System

Speed Sensorless Vector Control Based on Full-order Adaptive Observer for Induction Motor Drives at Low Speed

Regenerating Mode Stability Improvements for Combined Voltage and Current Mode Flux Observer in Speed Sensorless Induction Machine Control

Stability analysis and improvements for combined voltage and current mode flux observer of induction machine

Sensorless control and start-up strategy of permanent magnet synchronous motor

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Stability Improvement of Adaptive Full-Order Observer for Sensorless Induction Motor Drives in Low-Speed Regenerating Mode

A Speed Adaptive Scheme-Based Full-Order Observer for Sensorless Induction Motor Drives in Low-Speed Regenerating Operation Range

Operating-Point Tracking Method for Sensorless Induction Motor Stability Enhancement in Low-Speed Regenerating Mode

A Full-Speed Sensorless Control Algorithm For Interior Permanent Magnet Synchronous Motor Using Sliding-Mode Observer And Hf Signal Injection

Adaptive Speed Observer for Speed Sensorless Control of Induction Motor

The speed-sensorless control of induction motors at zero frequency