Abstract:Due to the extremely low Reynolds number, the mixing of substances in laminar flow within microfluidic channels primarily relies on slow intermolecular diffusion, whereas various rapid reaction and detection requirements in lab-on-a-chip applications often necessitate the efficient mixing of fluids within short distances. This paper presents a magnetic pillar-shaped particle fabrication device capable of producing particles with planar shapes, which are then utilized to achieve the rapid mixing of multiple fluids within microchannels. During the particle fabrication process, a degassed PDMS chip provides self-priming capabilities, drawing in a UV-curable adhesive-containing magnetic powder and distributing it into distinct microwell structures. Subsequently, an external magnetic field is applied, and the chip is exposed to UV light, enabling the mass production of particles with specific magnetic properties through photo-curing. Without the need for external pumping, this chip-based device can fabricate hundreds of magnetic particles in less than 10 min. In contrast to most particle fabrication methods, the degassed PDMS approach enables self-priming and precise dispensing, allowing for precise control over particle shape and size. The fabricated dual-layer magnetic particles, featuring fan-shaped blades and disk-like structures, are placed within micromixing channels. By manipulating the magnetic field, the particles are driven into motion, altering the flow patterns to achieve fluid mixing. Under conditions where the Reynolds number in the chip ranges from 0.1 to 0.9, the mixing index for substances in aqueous solutions exceeds 0.9. In addition, experimental analyses of mixing efficiency for fluids with different viscosities, including 25 wt% and 50 wt% glycerol, reveal mixing indices exceeding 0.85, demonstrating the broad applicability of micromixers based on the rapid rotation of magnetic particles.

Fabrication of Monodisperse Toroidal Particles by Polymer Solidification in Microfluidics

Tunable Morphology of Monodisperse Polymer Particles with Microfluidics

Droplet Microfluidics for Fabrication of Non-Spherical Particles

Polymer Particles with Various Shapes and Morphologies Produced in Continuous Microfluidic Reactors.

Fabrication of non-collapsed hollow polymeric nanoparticles with shell thickness in the order of ten nanometres and anti-reflection coatings

Fabrication of monodisperse, large-sized, functional biopolymeric microspheres using a low-cost and facile microfluidic device

Preparation of 10μm scale monodispersed particles by jetting flow in coaxial microfluidic devices

Controllable Preparation of Microscale Tubes with Multiphase Co-Laminar Flow in a Double Co-Axial Microdevice

Continuous Microfluidic Reactors For Polymer Particles

Solvent-Free Fabrication of Anisotropic Microparticles with Precise 3D Shape Control Using Dipping-Based Micromolding

Microfluidic Fabrication of Ceramic Microspheres with Controlled Morphologies

Production of monodispersed magnetic polymeric microspheres in a microfluidic chip and 3D simulation

Fabrication of microgel particles with complex shape via selective polymerization of aqueous two-phase systems.

Fabrication of Patterned Magnetic Particles in Microchannels and Their Application in Micromixers

Hyper-Miniaturisation of Monodisperse Janus Hydrogel Beads with Magnetic Anisotropy Based on Coagulation of Fe3O4 Nanoparticles

Flexible Microfluidic Fabrication of Anisotropic Polymer Microfibers

Generation of Monodisperse Particles by Using Microfluidics: Control over Size, Shape, and Composition

Flow-pattern-altered syntheses of core–shell and hole–shell microparticles in an axisymmetric microfluidic device

Nanostructures for all-polymer microfluidic systems

Top-down Approach for Fabrication of Polymer Microspheres by Interfacial Engineering

A microfluidic platform for the synthesis of polymer and polymer-protein-based protocells