Abstract:Superconducting cavity is the key equipment of the superconducting accelerator, which provides higher acceleration voltage and higher frequency power per unit length, and saves equipment space. Superconducting cavities need to be gradually cooled from ambient temperature (300 K) to the superconducting temperature (4.2 K or below) during the test and operation. The temperature difference on the cavity must be strictly limited during the cooldown process to prevent excessive thermal stress on the surface of the superconducting cavity. Since this cooldown process for the superconducting cavity is a typical large hysteresis, non-linear process that is difficult to control automatically using decoupled proportion integral derivative (PID) methods directly, a less efficient manual control scheme is normally adopted. In this paper, 3D numerical simulation, 1D pipe and 0D tank model with artificial neural network (ANN) were combined to generate a two-layer surrogate model that can balance computational accuracy and speed, to improve the automation and cooling efficiency of the superconducting cavity cooldown process. In order to achieve automatic control of the cooling procedure for the superconducting cavity, a model predictive control (MPC) approach was also built on the basis of this two-layer surrogate model. According to the results of the experiment test, the improved method could realize a quick and smooth cooldown process of the superconducting cavity, during which the temperature difference on the cavity could satisfy the requirements. Additionally, the improved automatic cooldown method was more adaptable and saved 29 % more time than the original manual control method. The foundation for a more intelligent automated control of future large cryogenic systems or other system with the large hysteresis, non-linear properties, was laid.

Dual-variable Decoupling Control of a Cold and Hot Helium Gas Mix Process

Numerical Study on the Working Performance of a G-M Cryocooler with a Mechanically Driven Displacer

Automatic control of precooling process in EAST cryogenic system based on DCS

Research on Voltage Decoupling Control of Vector Control for Permanent Magnet Synchronous Motor

A MIMO Decoupling Algorithm for Rapid Heating Systems of Wafers

Research on Decoupling Control in Temperature and Humidity Control Systems.

Nonlinear dynamic behaviors and control based on simulation of high-purity heat integrated air separation column.

Automatic control of supercritical helium circulating pump in EAST cryogenic system

Dynamic Matrix Control for Cold Helium Temperature of Multi-Modular High Temperature Gas-Cooled Reactor Plant

Decoupling Control and Simulation for Variable Flow Heating Systems

A Pulsed Current Charging Mechanism for High Temperature Superconducting Magnets

Remote cryogenic helium gas circulating cooling system for a 10-Mvar class HTS dynamic synchronous condenser

Modeling and Decoupling Control Simulation for a Virtual Coupling Heater System

Robust Control Of A Four Axis Hts Coil Based Maglev System

Design and Experimental Investigations on the Helium Circulating Cooling System Operating at Around 20 K for a 300-kvar Class HTS Dynamic Synchronous Condenser

Automation of superconducting cavity cooldown process using two-layer surrogate model and model predictive control method

OPTIMIZATION OF ACTIVE MAGNETIC BEARINGS' POWER SUPPLY SYSTEM FOR MAIN HELIUM FAN IN HIGH TEMPERATURE GAS-COOLED REACTOR

Research of the Temperature Decoupling Control for a MCFC/GT Hybrid System

Magnetic Conduction Structure Design and Charging Test of a Linear-Motor Type Flux Pump for Through-Dewar Excitation of High Temperature Superconducting Motors

The Cooling and Safety Design of a Pair of Binary Leads for the MICE Coupling Magnets

Study on Forced Flow Cooling of Superconducting Magnet for Compact Synchrotron