Abstract:In practical engineering, the magnitude of soil unloading rebound is closely related to the physical and mechanical properties of the soil. Therefore, there are significant differences in geological conditions among the different regions. As such, targeted research on the rebound law and calculation methods of foundation pits is needed. This article reports indoor experiments and numerical simulation methods which are used to study the trends and calculation methods of foundation pit rebound based on typical geological conditions in South China. Our findings are as follows. 1) At maximum consolidation stress ranging from 100 kPa to 400kPa, the maximum rebound rate of plain fill soil in typical soil layers is 0.0539–0.0704, the rebound rate of silty clay is 0.0373–0.0528, the rebound rate of coarse sand is 0.0296–0.0343, the rebound rate of gravelly cohesive soil is 0.0159–0.0305, the rebound rate of fully weathered granite is 0.0175–0.0344, and the rebound rate of strongly weathered granite is 0.0170–0.0379. 2) The rebound indices do not change with changes in the unloading ratio or initial consolidation stress. The rebound indices of the soil layer from top to bottom are 0.0143, 0.0119, 0.0077, 0.0096, 0.0083, and 0.0076, respectively, and a formula for calculating the rebound modulus of typical soil layers in South China was proposed. 3) The pore ratio of the soil after the end of the recompression process is lower than that which occurs after the first compression. The difference between the compression porosity ratio of the soil layer from top to bottom and the compression porosity ratio is 0.1, 0.08, 0.02, 0.06, 0.02, and 0.03, respectively. 4) The calculation of the depth of influence by the self-weight stress offset method is based on the theory of eliminating self-weight stress and unloading stress. The calculation depth is not affected by geological conditions, the formula for calculating the rebound modulus is consistent with the formula obtained from experimental research, and the calculation results are in good agreement with the numerical values.

Experimental Study on Detecting Concrete Compression Strength with Rebound Method for Lanzhou Area

Experimental research on the strength of concrete mearsured by limpet

Experimental Research on Concrete Strength Prediction by Limpet Pull-off Test in China

Testing the Self-compacting Rock-fill Concrete Strength by the Rebound Method

EXPERIMENTAL STUDY OF THE DETECTING METHOD FOR COMPRESSIVE STRENGTH OF NON-STANDARD CONCRETE HOLLOW BLOCK

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

Experimental investigation on the test method for compressive strength of non-standard hollow concrete block

Research on Rebound Strength Measurement Curve of Modified Carbonation Depth of Machine-Made Sand Concrete

Research on test technology of concrete lateral pressure

Experimental Study on Lateral Resistance Behavior of Small Concrete Hollow Block Wall with Different Constructional Measures

Pile Foundation Test Experimental Program of Lanzhou New City Science and Technology Innovation

Establishing Curve for Measuring Strength to Detect Compression Strength with Resilience Method for Ningxia Municipality

Comparison of Evaluation Tests for Compressive Strength of Structural Concrete

Prediction Model of Compressive Strength Development in Concrete Containing Four Kinds of Gelled Materials with the Artificial Intelligence Method

Detection of prepreg basalt fiber concrete strength with rebound method

Experiment and Analysis of Local Compression Bearing Capacity of Reactive Powder Concrete

Detecting Compressive Strength of Pouring Piles Concrete by Ultrasonic Method

Correlation Analysis of Dayangshan Rock Strength in Suzhou

An Analysis of the Resilience Capacity of Soils in North China: a Study on Land Subsidence Treatment

Research on the rebound rule of a pit bottom caused by excavation of typical strata

Field Rebound and Recompression Curve of Soft Clay