Abstract:A 3D thermo-mechanical constitutive model for the polycrystalline shape memory alloy (SMA) has been used to predict the superelastic response of the textured thin-walled NiTi tubes under combined tension–torsion loading. This model is based on the work of Lim et al. and Wang. Considering the difference of Young’s modulus between austenite and martensite phase, some formulas have been modified. The new developed model has been implemented into ABAQUS as UMAT. In order to validate the model, thin-walled tube has been tested under biaxial loading. From the comparison between the simulated and experimental results, it is found that the model is quite good in predicting the overall loading–unloading process of the SMA. Both the experimental and simulated results demonstrate the significant differences in the superelastic responses under different biaxial loading paths. For both biaxial loading paths, at relatively low level of tensile strain, the overall behaviour of the tubes is smooth. But with the increase of the tensile strain level, the equivalent stress–strain curves fluctuate. For torsion–tension loading program, corresponding to about 4% strain, stress decrease upon tensile loading and stress increase upon tensile unloading are observed due to the change of shear stresses. For Type II loading program (tension followed by torsion, unload in reverse order), a stress decrease upon loading and a stress increase upon unloading are observed but the corresponding strains become big with the increase of the tensile strain level. In addition, according to the simulated results, the rate of martensite formation under tensile loading is higher than that under shearing loading.

Phenomenological Modeling of the Cyclic Behavior of Superelastic Shape Memory Alloys

Two-Dimensional Analysis of Shape Memory Alloys under Small Loadings

A Phenomenological Model for Thermally-Induced Hysteresis in Polycrystalline Shape Memory Alloys with Internal Loops

A one-dimensional strain-rate-dependent constitutive model for superelastic shape memory alloys

Improved One-Dimensional Constitutive Model of Superelastic Shape Memory Alloy Wires

Experimental and Numerical Study of the Superelastic Behaviour on NiTi Thin-Walled Tube under Biaxial Loading

Cyclic Model for Superelastic Shape Memory Alloy Based on Neural Network

Constitutive Model of Shape Memory Alloy Based on Plastic Theory:Experiment and Simulation

Micromechanical Modeling on Thermomechanical Coupling of Cyclically Deformed Superelastic NiTi Shape Memory Alloy

Modeling and Simulation of SMA Wire Actuator

Constitutive Modeling of Functional Fatigue with Tension-Compression Asymmetry for Superelastic NiTi Shape Memory Alloy

A Thermomechanically Coupled Finite Deformation Constitutive Model for Shape Memory Alloys Based on Hencky Strain

A new constitutive model of superelastic shape memory alloy

A Macromechanical Constitutive Model of Shape Memory Alloys under Uniaxial Cyclic Loading

A constitutive model for superelastic shape memory alloys considering the influence of strain rate

Constitutive Modelling of Transformation Pattern in Superelastic NiTi Shape Memory Alloy under Cyclic Loading

An Extended Thermomechanically Coupled 3D Rate-Dependent Model for Pseudoelastic SMAs under Cyclic Loading

DYNAMICAL BEHAVIOR AND CONSTITUTIVE MODEL OF SUPERELASTICITY NITI SHAPE MEMORY ALLOY WIRE : EXPERIMENT AND THEORY

A Constitutive Model of Shape Memory Alloys with Consideration of Martensitic Hardening Effect

Modeling evolutions of plastic strain, maximum transformation strain and transformation temperatures in SMA under superelastic cycling

A Temperature-Dependent Model of Shape Memory Alloys Considering Tensile-Compressive Asymmetry and the Ratcheting Effect.