Abstract:In order to investigate the wind-resistant safety conditions of light-weight steel portal frame structures, the wind pressures on the surface of a light-weight steel industrial building located at the southeast coastal area of China were measured by means of the wind-tunnel test technique. The wind loads under two most unfavorable wind directions obtained from the measured data and the loads determined from the load code for building structures and the technical specification for steel gable frame structures were applied to the unfavorable frame of the building. The nonlinear load-capacity analyses were then performed using the refined plate/shell element based finite element method, and the wind-resistant safety factors and ultimate-state failure modes of the frame were thereafter found. Analysis and comparison of the obtained wind-resistant safety factors under different load cases, indicate that the degrees of safety redundancy of the frame in consideration under the wind load determined from the steel gable frame specification and the extreme wind load from the wind tunnel test are relatively low, and the wind resistant design in accordance with the load code wind loading (no gust factor included) would probably lead the frame to an unsafe condition. A simple and effective beam-column connection enhancement measure is proposed thereafter, by which the safety level of the frame could be considerably improved and the sensibility to initial imperfections could be reduced.

Practical method for calculating effective length coefficient for pillar of main frame of steel arc gates

COMPARISON OF EFFECTIVE LENGTH COEFFICIENT OF CONSTANT-SECTION STEEL FRAME-COLUMN BETWEEN CHINESE AND AMERICAN DESIGN SPECIFICATIONS

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Wind-resistant safety analysis of light-weight steel portal frame structures

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

TORSIONAL DEFORMATION CALCULATION OF LARGE SPAN THIN-WALLED STEEL BOX GIRDER WITH OPEN SECTION

CALCULATING METHODS OF THE STABILITY BEARING CAPACITY OF FRAME SCAFFOLDING WITH STEEL TUBES

Calculating Method and Experimental Research on Lateral Load Distribution of Transversely Strengthened Hollow Slab Bridge

New Method for Calculation of Radial Gate Sheet

Research on effective length of concrete filled steel tubular planar frame columns

Stability Analysis for Semi-Rigid Jointed and Braced Steel Frames

OPTIMAL DESIGN ANALYSIS OF PORTAL FRAME OF ORDINARY STEEL STRUCTURE WORKSHOP WITH LIGHTWEIGHT ENCLOSURE

COMPARATIVE STUDY OF DESIGN METHODS FOR STEEL COLUMNS STRENGTHENED BY WELDING WHILE UNDER AXIAL AND ECCENTRIC LOAD IN DIFFERENT CODES

Calculational method of shear deformation for beam-to-column connection panel zone in steel frames

Comparative Study of Design Procedures for Cfst-To-Steel Girder Panel Zone Shear Strength

STUDY ON THE DESIGN METHOD FOR STEEL STRUCTURE HEATING FURNACE IN PETROCHEMICAL INDUSTRY

Two Calculation Methods for Buckling Reduction Factors of Stainless Steel Welded I-Section Beams

Preliminary Research on Effective Length of Concrete Filled Steel Tubular Columns in Sway Frame

Calculation of the Foundation of Portal Frame Light Steel Structure Industrial Building

CALCULATION METHOD ON MOMENT-ROTATION CURVES OF BEAM-TO-COLUMN SEMIRIGID END-PLATE CONNECTIONS