Abstract:Abstract In modern technology there are devices whose details are subject to thermal effects. As a result, the properties of materials may change in parts. In turn, this leads to the failure of the device. You can control surface temperature to protect components from excessive heat. The temperature measuring device cannot be placed at the point where the heating takes place, since the heating temperature is too high. On the other hand, the temperature of the outer side of the protective layer itself is of little interest: you need to know the temperature on the surface of the material. Therefore, one can either, knowing the temperature at the material-protective layer media section, solve the inverse problem, or solve the heating control problem. In this paper, we propose to consider the problem of controlling heating under the condition of controlling the temperature of the interface. We consider the problem on a half-line, and the following sections are identified in the problem: the heating region, a small thickness of the protective layer, the region occupied by the material, and the semi-infinite region in which the material interacts with the environment. At the same time, we consider such a coefficient of thermal conductivity that it is constant in each of the regions, but it experiences a first-order discontinuity at the interfaces. This makes it impossible to build a classical solution to the problem in the entire solution area, and we build solutions that are classic, each in its own subregion, and that meets the matching conditions at the interfaces. The control problem is as follows: the heating function, on the one hand, should be maximum all the time, and on the other, the temperature at the interface should not exceed a certain critical value (for example, the melting temperature of the material). The constructed solution of the problem is simple, but requires rather cumbersome proofs.

Study of Hyperbolic Heat Conduction Problem in the Film and Substrate Composite with the Interface Resistance

Study of Hyperbolic Heat Conduction Problem in IC Chip

Numerical Analysis for the Hyperbolic Heat Conduction Problem under a Pulsed Surface Disturbance

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

The Thermal and Pasternak Foundation Effect on the Transient Behaviors of the Rectangular Plate Using a Novel Semi-Analytical Method

Analysis for Microscopic Hyperbolic Two-Step Heat Transfer Problems

Numerical solutions for the hyperbolic heat conduction problems in a layered solid cylinder with radiation surface

Numerical Analysis for Dual-Phase-Lag Heat Conduction in Layered Films

Analytical Solution of Heat Conduction for Hollow Cylinders with Time-Dependent Boundary Condition and Time-Dependent Heat Transfer Coefficient

Numerical simulation for non-linear thermal wave

Analysis of Dual-Phase-lag Thermal Behaviour in Layered Films with Temperature-Dependent Interface Thermal Resistance

Analysis of Thermal Behavior in Multi-Layer Metal Thin Films Based on Hyperbolic Two-Step Model

An Asymptotic Local Solution for Axi-Symmetric Heat Conduction Problems with Temperature Discontinuity on the Boundary

Numerical Analysis of Dual-Phase-lag Heat Transfer in a Layered Cylinder with Nonlinear Interface Boundary Conditions

Thermomechanical analysis of the effect of contact forces in heat conduction of composite materials through multiscale contact finite element modeling

The control problem for the heat equation in the case of a composite material

Heat Transfer in Composite Materials with Stefan–Boltzmann Interface Conditions

APPLICATION OF HYBRID LAPLACE TRANSFORM/ FINITE-DIFFERENCE METHOD TO TRANSIENT HEAT CONDUCTION PROBLEMS

Numerical Simulation and Theoretical Analysis of Thermal Boundary Characteristics of Convection Heat Transfer in Porous Media

A general numerical method for solving the three-dimensional hyperbolic heat conduction equation on unstructured grids