Abstract:To address the issues of high oxygen content and energy consumption in the microwave-assisted pyrolysis of biomass for biofuel production, this study used high-temperature pretreated red mud (RM) as an additive. The pretreated RM exhibited dual functionalities, namely microwave absorption and catalytic properties, during the microwave-assisted pyrolysis of cow dung (CD). This study also evaluated the optimization potential of energy recovery efficiency. The results showed that the addition of pretreated RM significantly increased the oil yield during the microwave-assisted pyrolysis of CD. The highest oil yield (59.63%) was obtained via the microwave-assisted pyrolysis of CD over catalysis with RM pretreated at 750 °C (RM750). Through the optimization of the RM750-to-CD mixing ratio, optimal oil quality and energy recovery efficiency were achieved. At a mixing ratio of 1:1, the pyrolysis oil featured the highest aromatic hydrocarbon content and lowest acid content. The high-temperature pretreatment of RM increased the Fe2O3 content, which enhanced the dielectric properties and magnetic loss ability of the reactants. This resulted in localized high temperatures and the formation of "hot spots," which can promote the deoxygenation and hydrogenation reactions of oil. Consequently, the lower heating rate of oil increased from 35.12 to 40.11 MJ kg-1. The released oxygen escaped in the form of CO. In addition, pyrolytic char was used as an in situ microwave absorbing material owing to its increased Fe2O3 content and graphitization degree, leading to an increase in energy recovery efficiency from 4.71% to 9.98%. This study provides valuable guidance for the efficient utilization of diversified solid wastes and demonstrates the potential application of microwave-assisted pyrolysis technology in the resource utilization of solid wastes.

Study on Microwave Pyrolysis of Corn Straw

Porous biochar production from pyrolysis of corn straw in a microwave heated reactor

EXPERIMENTAL RESEARCH ON CORNCOB FAST PYROLYSIS FOR BIO-OIL IN A FLUIDIZED BED REACTOR

Selective Production of Phenol-Rich Bio-Oil From Corn Straw Waste by Direct Microwave Pyrolysis Without Extra Catalyst

Study of co-pyrolysis endpoint and product conversion of plastic and biomass using microwave thermogravimetric technology

Hydrogen-rich fuel gas from rice straw via microwave-induced pyrolysis

Pyrolysis of corn stalks: The potential of using bio-oil as a fuel

Fast Pyrolysis Product Distribution of Biopretreated Corn Stalk by Methanogen.

Comparative study on fuel characteristics and pyrolysis kinetics of corn residue-based hydrochar produced via microwave hydrothermal carbonization

Effect of Torrefaction on the Physiochemical Characteristics and Pyrolysis of the Corn Stalk

Effects of Biopretreatment on Pyrolysis Behaviors of Corn Stalk by Methanogen

The preparation of high-grade bio-oils through the controlled, low temperature microwave activation of wheat straw

Microwave-assisted catalytic upgrading of co-pyrolysis vapor using HZSM-5 and MCM-41 for bio-oil production: Co-feeding of soapstock and straw in a downdraft reactor

Heating performances of corn straw particles in a microwave chamber

Promotion of bio-oil production from the microwave pyrolysis of cow dung using pretreated red mud as a bifunctional additive: Parameter optimization, energy efficiency evaluation, and mechanism analysis

Torrefaction of agriculture straws and its application on biomass pyrolysis poly-generation

Effects of variable amounts of volatiles in corncob on microwave co-pyrolysis of low-rank coal and corncob

Comparison of corn straw biochars from electrical pyrolysis and microwave pyrolysis

Study on the pyrolysis properties of corn straw by TG–FTIR and TG–GC/MS

A kinetics study of microwave pyrolysis of sewage sludge and corn stalk mixture

Dielectric characterisation and reduction properties of the blending mixtures of low-grade pyrolusite and waste corn stalks in the microwave field