Abstract:To address the challenges posed by large propagation loss and severe multipath delay spread, while aiming to improve communication rates in long-range underwater acoustic (UWA) communication, this paper introduces a novel approach: multi-beam (MB) Orthogonal Frequency Division Multiplexing (OFDM) based on deconvolved conventional beamforming (dCv). The proposed method establishes a signal processing framework for UWA channel receivers, wherein received signals corresponding to each angle beam are isolated and concentrated using the dCv technique. Subsequently, the separated signals from each angle undergo maximal-ratio combining (MRC) channel equalization followed by demodulation. Compared to conventional single-beam (SB) processing methods, the proposed approach capitalizes on multipath diversity gain achieved by combining MB outputs originating from various arrival angles. Moreover, employing dCv processing demonstrates superior performance compared to popularly employed beamforming techniques, especially when dealing with paths arriving from closely aligned angles. Additionally, the array beamforming utilized significantly enhances the signal-to-noise ratio (SNR) of each beam output, mitigating the elevated error rates in channel estimation associated with combining low SNR signals received from individual elements. Simulation results utilizing BELLHOP and experimental data from the South China Sea showcase notably improved bit error rate (BER) performance for the proposed method compared to SB equalization, MB-MRC equalization based on conventional beamforming (CBF), minimum variance distortionless response (MVDR), and worst-case performance optimization (WCPO), as well as standard MRC equalization techniques. The proposed receiver achieves error-free decoding results at a communication distance of 80 km with a data rate of 247 bps.

Simulation research on the performance of underwater hyper beam forming

Sparse-reconstruction-based high resolution beamforming and its application to multi-beam systems

Hexagonal Array Fast Fourier Transform Beamforming Algorithm

Fast broadband beamforming based on vector hydrophone array

A Real-Time 3-D Underwater Acoustical Imaging System

An Imaging Algorithm for High-speed Side-scan Sonar Based on Multi-beam Forming Technology

Steerable Simultaneous Multibeam Antenna Based on Reconfigurable Reflectarray

Multi-Frequency Transmitting Beamforming Algorithm Based on Cross Array

Cross Power Spectral Density Based Beamforming for Underwater Acoustic Communications

An Efficient Near-Field Parallel Subarray Beamforming for Portable 3D Imaging Sonar

Distributed and Parallel Subarray Beamforming for Underwater Real-Time 3-D Acoustic Imaging

Signal Processing Algorithm and System Realization of Broadband Parametric Array Sub-Bottom Profiler

Standardizing constants for ultrasonic biometry, keratometry, and intraocular lens power calculations

Design of Simultaneous Multi-beam Forming Method

Design of Low-Complexity 3-D Underwater Imaging System with Sparse Planar Arrays

Feature-Enhanced Beamforming for Underwater 3-D Acoustic Imaging

High-performance deep-sea long-range underwater acoustic communication: Deconvolved conventional beamforming based approach

Distributed and parallel subarray beamforming for near-field 3D sonar imaging

A Low-Complexity Real-Time 3-D Sonar Imaging System with a Cross Array

Design of Portable Three-Dimensional Sonar for Both Far-Field and Near-Field

Pruned Distributed and Parallel Subarray Beamforming for 3-D Underwater Imaging With Fine-Grid Sparse Arrays