Intelligent electrical equipment fiber Bragg grating temperature measurement system
Anhua Peng,Chengwen Liu,Le Yang
DOI: https://doi.org/10.1186/s13634-021-00793-9
2021-09-25
EURASIP Journal on Advances in Signal Processing
Abstract:Abstract Fiber Bragg gratings are widely used in electrical equipment monitoring, structural health monitoring, power system fault monitoring and other actual detection occasions due to the unique advantages of anti-electromagnetic interference, low fusion loss, high sensitivity, small size, and easy distributed measurement. Fiber grating has been widely used in actual detection occasions such as electrical equipment monitoring, structural health monitoring, and power system fault monitoring. The temperature measurement of the motor based on fiber grating sensing technology not only has strong anti-electromagnetic interference ability, but also can realize multi-point distributed temperature measurement. The research of fiber grating temperature measurement system for intelligent electrical equipment is of great significance. This article mainly studies the optical fiber grating temperature measurement system of intelligent electrical equipment. This paper designs the temperature measurement system architecture, including data acquisition layer, data monitoring layer and remote monitoring layer. Complete the system design from two aspects: hardware design and software design. In the hardware part, the functions of the temperature sensor module transmission system, signal demodulation system, PLC and host computer are analyzed. Use FTM3501 fiber temperature converter is used to realize the automatic electrical fiber grating. Experimental results show that the thermometer has alarm and display analysis functions. The measurement uncertainty is analyzed, and the uncertainty of the calibration result of the fiber Bragg grating temperature sensor is 0.0725 °C; the fault judgment time of the system in this paper does not exceed 4.73 s, while the fault judgment time of the control group is more than 4.73 s. Compared with the control group, it has a faster fault accuracy speed. The system has high measurement accuracy and good stability, can be applied to actual temperature measurement systems, and has certain practical value.
engineering, electrical & electronic