Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Enhanced Light Response of Titania Nanotube Arrays Sensitized with Pyrite Fes2

Hydrothermal Growth of Nanorod Arrays and in Situ Conversion to Nanotube Arrays for Highly Efficient Ag-sensitized Photocatalyst

A novel approach to titania nanowire arrays as photoanodes of back-illuminated dye-sensitized solar cells

FeS2-sensitized ZnO/ZnS Nanorod Arrays for the Photoanodes of Quantum-Dot-sensitized Solar Cells

Highly Enhanced Photoelectrocatalytic Properties by Α-Fe 2 O 3 Modified NF-TiO 2 Pyramids with Dominant (101) Facets

Template-directed Synthesis of Pyrite (fes2) Nanorod Arrays with an Enhanced Photoresponse

Preparation of FeS2 Nanotube Arrays Based on Layer-by-layer Assembly and Their Photoelectrochemical Properties

Synthesis of α-Fe2O3/TiO2 nanotube arrays for photoelectro-Fenton degradation of phenol

Fabrication of composite Fe 2O 3 nanotube arrays for contaminants degradation and hydrogen generation under visible light irradiation

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Titania Nanoflowers with High Photocatalytic Activity

Fabrication of Fe<SUB>2</SUB>O<SUB>3</SUB>/TiO<SUB>2</SUB> Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Distinct visible-light response of composite films with CdS electrodeposited on TiO2 nanorod and nanotube arrays

Fabrication of Fe2O3/TiO2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation: Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of titania thin film with composite nanostructure and its ability to photodegrade rhodamine B in water

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Synthesis and Photoinduced Charge-Transfer Properties of a ZnFe2O4-sensitized TiO2 Nanotube Array Electrode.

Enhanced Photoelectrochemical Performance of PbS Sensitized Sb–SnO2/TiO2 Nanotube Arrays Electrode under Visible Light Illumination

Enhanced Efficiency for Dye-Sensitized Solar Cells Using A Surface-Treated Photo-Anode

Big-leaf hydrangea-like Bi2S3-BiOBr sensitized TiO2 nanotube arrays with enhanced photoelectrocatalytic performance