Abstract:In this research, a scintillation detector was developed using the CsI(Tl) scintillator crystal coupled with a silicon photomultiplier (SiPM) to replace the photomultiplier tube (PMT), resulting in a compact and energy-efficient detector. A rectangular box-shaped CsI(Tl) scintillation crystal with dimensions of 50x25x25 mm from Kinheng and a SiPM module S13361-3050AE-08 with dimensions of 25x25 mm from Hamamatsu were selected to use. The preamplifier circuit, power supply, and temperature stabiliser have also been integrated into the detector. The characteristics of this detector were evaluated using a 137Cs standard radioactive source together with Ortec’s multichannel analyser device and Gamma Vision software for spectrum analysis. Results showed that the energy resolution for the 137Cs peak of this detector is about 8.03%, which is almost equivalent to the energy resolution of 7.87% of the Canberra detector using 76x76 mm NaI(Tl) crystal coupled to the PMT. The results of the evaluation of stability over time when the operating ambient temperature of this detector with no change showed that the energy peak position and the energy resolution for the 137Cs radioactive source are almost unchanged. The research also investigated the stability of the detector according to the operating ambient temperature. The results exhibited that the output pulse amplitude varies greatly with the ambient temperature, it decreases when the temperature increases and vice versa. Under the condition that the operating ambient temperature varies from 11oC to 50oC, the energy peak position of 137Cs changes were 1762 and 167 channels, respectively in the cases without and with adjustment of output pulse amplitude stabilisation function in power supply for SiPM. When there is a function of output pulse amplitude stabilisation, the change in peak position according to operating ambient temperature is still about 4.3 channels/oC, so further research is needed to correct the influence of ambient temperature on the operation of this detector, to provide wide applicability of scintillation detector using SiPM to replace traditional PMT in the future.

Monte Carlo Simulation of the Detection Efficiency and Output Current of CsI(Tl) Scintillation and Photoelectric Diode Detectors

Monte Carlo Simulation of CsI(Tl) Scintillator Detector with GEANT4 ToolKit

Double Junction Photodiode for X-Ray Cmos Sensor Ic

Design and manufacture of scintillation detector using CsI(Tl) crystal coupled with silicon photomultipliers

Csi(Ti) Detector with Position-Sensitive Photomultiplier Readout

Study on the performance of a large-size CsI detector for high energy γ -rays

Incident Position Dependence of the Energy Response of CsI(Tl) to Charged Particle

Monte Carlo simulation for transmission of photon in scintillation crystal

Comparative Study of NaI,BGO,LSO,GSO and YSO Scintillators Using Monte Carlo Simulations

Balancing Performance and Portability: A Study on CsI(Tl) Crystal Sizes for Real-Time Gamma-Ray Spectrum and Dose Monitoring

Cs3Cu2I5 Single Crystal for Efficient Direct X‐Ray Detection

Property Investigation of the Wedge-Shaped CsI(Tl) Crystals for a Charged-Particle Telescope

Studies of Prototype CsI(Tl) Crystal Scintillators for Low-Energy Neutrino Experiments

A Real-Time Energy Response Correction Method for Cs3Cu2I5:Tl Scintillating Dosimeter

A Study on Determination of an Optimized Detector for Single Photon Emission Computed Tomography

Energy Calibration of CsI(Tl) Crystal for Quenching Factor Measurement in Dark Matter Search

Nuclear Counter Effect of Silicon Photodiode Used in Csi(Tl) Crystal Calorimeter

Growth and Evaluation of Improved CsI:Tl and NaI:Tl Scintillators

Property Investigation for Different Wedge-Shaped CsI(Tl)s

In-Silico Optimisation of Tileable Philips Digital SiPM Based Thin Monolithic Scintillator Detectors for SPECT Applications

Development of a Monte Carlo simulation platform for the systematic evaluation of photon-counting detector-based micro-CT