Abstract:The extrudate swell ratios of polypropylene (PP) composite melts filled with graphene nano-platelets (GNPs) were measured using a capillary rheometer within a temperature range of 180-230 degrees C and apparent shear rate varying from 100 to 4000 s(-1) in order to identify the effects of the filler content and test conditions on the melt die-swell behavior. It was found that the values of the extrudate swell ratio of the composites increased with increasing apparent shear rate, with the correlation between them obeying a power law relationship, while the values of the extrudate swell ratio decreased almost linearly with rise in temperature. The values of the melt extrudate swell ratio increased approximately linearly with increasing shear stress, and decreased roughly linearly with an increase of the GNP weight fraction. In addition, the extrudate swell mechanisms are discussed from the observation of the fracture surface of the extrudate using scanning electronic microscopy. This study provides a basis for further development of graphene reinforced polymer composites with desirable mechanical performance and good damage resistance. (C) 2015 Elsevier Ltd. All rights reserved.

Study on Extrusion-swell Behavior of PP/MRP Composites

Research on Melt Density and Flow Properties of PP/MRP Composites

Extrudate Swell Behavior of Polypropylene Composites Filled with Microencapsulated Red Phosphorus

Melt flow properties and morphology of polypropylene composites filled with microencapsulated red phosphorus

Melt Shear Flow Behavior of Flame-Retardant Polypropylene Composites Filled with Microencapsulated Red Phosphorus

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Mechanical properties and morphology for polypropylene composites filled with microencapsulated red phosphorus

Research on Extrusion Swell Behaviour of FEP/PP Blend Melt

Melt extrudate swell behavior of multi‐walled carbon nanotubes filled‐polypropylene composites

Study on preparation and properties of MRP/HDPE composite

Effects of Extrusion Conditions on Die Swell Behavior of PP/Diatomite Composites

Research on Die-swell Behavior During Extrusion of Polyformaldehyde Blends and Composites

Melt Rheology during Extrusion of Polypropylene Composites Filled with Diatomite Particles

Rheological Properties of PP/Glass Bead Composite

The Melt Die-Swell Behaviour During Capillary Extrusion of Ldpe/Pp Blends

Mechanical Properties and Flame-Retardant of PP/MRP/Mg(OH)2/Al(OH)3 Composites

Studies on melt flow properties during capillary extrusion of PP/Al(OH)3/Mg(OH)2 flame retardant composites

Research into Melt Flow Properties of Polypropylene/Diatomite Composites

Melt Extrudate Swell Behavior of POM/EVA/HDPE/nano-CaCO3 Composites

Melt Extrudate Swell Behavior of Polypropylene Composites Filled with Hollow Glass Beads

Melt Extrudate Swell Behavior of Graphene Nano-Platelets Filled-Polypropylene Composites