Abstract:High-performance manufacturing (HPM) is essential for high-quality equipment and parts manufacturing, which requires not only geometric accuracy but also control of surface integrity to satisfy functional performance. Surface topography and residual stress are important elements of surface integrity. However, they are always investigated individually, and their collaborative formation pattern has been ignored for a long time. In this study, surface topography will be measured by a 3D laser scanning microscope and analyzed from the perspective of spectral wavelength ( λ ) along with its corresponding amplitude. Whereas the residual stress (RS) is going to be analyzed by X-Ray diffraction and finite element (FE) model. Thereafter we introduce the formation pattern of both surface topography and RS. Hereby, simulated points clouds of machined surface topography are generated by superimposing the normally distributed random numbers that take into account the springback of the workpiece material response on tool kinematics and geometry. Furthermore, the RS is divided into mechanical loads induced ( RS M ) and thermal loads induce ( RS T ) according to the mechanism of formation, which were obtained in cutting speed (Y-direction) and feed direction (Z-direction) by the Mohr circle. Our experimental and numerical results showed that an increase in the feed rate (from 0.05 mm/r to 0.15 mm/r) significantly increases the surface roughness and cutting temperature. The increase in temperature increased the RS T by up to 286.1%, resulting in a reduction of compressive RS in Z-direction and an increase of tensile RS in Y-direction. Moreover, the increase in cutting speed (from 40 m/min to 80 m/min) results in a more regular surface and a reduction in surface roughness because of the smaller springback. At the same time, it also leads to a decrease of RS M in Z-direction and an increase of RS M in Y-direction. In addition, the increment in cutting speed leads to a minor increase in temperature and RS T (maximum increase of 47.0%). Combining the effects of RS M and RS T , RS in both directions increases slightly.

FEM optimization of tool geometry based on the machined near surface's residual stresses generated in diamond turning

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Elastic-plastic finite element simulation for diamond turning process

FE Simulation of Diamond Turning with Different Friction Coefficients

Finite Element Analysis for the Influence of Rake Angles of Diamond Tool on Ultraprecision Cutting Process

Optimization of process parameter of residual stresses for hard turned surfaces

Simulation of Cutting Tool Geometry Parameters Impact on Residual Stress

On Predicting Residual Stress And Chip Morphology In Pre-Stressed Hard Turning

An accurate 3D surface topography model for single-point diamond turning

Numerical and experimental investigations on residual stress evolution of multiple sequential cuts in turning

Collaborative formation pattern of surface topography and residual stress in hard turning of steels

Finite Element Simulation of Residual Stress on the Surface in the Cutting Considering Tool Flank Wear

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies

The Periodical Fluctuation of Residual Stress in Hard Turned Surface and Its Relationship with Chip Formation

Evolution of residual stress when turning a fillet radius in stainless steel

Predicting The Effects Of Tool Nose Radius And Lead Angle On Hard Turning Process Using 3d Finite Element Mothod

Tool Geometry Effect on Machined Surface Integrity in Precision Turning High-Strength Spring Steel

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Predicting the Effects of Tool Nose Radius and Lead Angle on Hard Turning Process Using 3D Finite Element Method

Finite element analysis of residual stresses and thin plate distortion after face milling

Modelling and Optimization of Machining of Ti-6Al-4V Titanium Alloy Using Machine Learning and Design of Experiments Methods