Abstract:Brake-by-wire systems are one of the key components in intelligent/unmanned vehicles that have attracted worldwide attention. Testing and evaluation of brake-by-wire systems are a significant step during the development of the technology of vehicular braking and further the advancement of intelligent/unmanned vehicles. Using the test bench to simulate different road adhesion coefficients (i.e. road surfaces) and to complete the testing and evaluation of the vehicle braking systems is of great significance and importance. A test bench for simulation of vehicular braking of 1/4 vehicle is presented and investigated in this article. It is composed of a motor, two rollers, a 1/4 vehicle suspension system, a magnetic powder clutch, a flywheel, sensors, a signal acquisition and processing system, and a controller. The wheel and vehicle speeds are simulated by the rollers and flywheel speeds, respectively. The translational kinetic energy of 1/4 vehicle is simulated by the rotational kinetic energy of the flywheel. The signal acquisition and processing system is used to acquire and process the experimental signals, such as rotational speeds and torques during tests. The magnetic powder clutch with adjusted applied currents in the test bench is used to real-timely simulate roads with different adhesion coefficients. Based on the working principle of the test bench and the fundamentals of vehicle dynamics, the prototype of the test bench is established and the simulation approach of the translational kinetic energy of 1/4 vehicle is investigated. The mathematical model of the real-time simulation about roads with different adhesion coefficients based on the magnetic powder clutch with real-time controllable transmitted torque is established. With the built 1/4 vehicle braking systems based on the test bench and road, and the corresponding established models, the comparison and analysis of the simulation results of various road surfaces are conducted. Experiments are sequentially implemented to verify the feasibility and effectiveness of the test bench.

An Experimental Study on the Transfer Path of the Steering Wheel Wobbling Induced by Brake Judder

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

Analysis of Clutch Engagement Judder and Its Influence Factors

Research on Modeling and Load Simulation Algorithm of Tracked Vehicle Braking System on Mu-Split Road Surfaces

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Research on Force Characteristics of Steering-wheel System in Tracked Vehicle Simulator

Handling characteristics of drivers under braking conditions considering the fluctuation in the steering-wheel torque

STUDY ON STEERING WHEEL SHIMMY OF A CAR AT HIGH VELOCITY

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Vibration control and structural optimization of steering brake assist device in new energy buses

Double-Drum Test Bench for Variable Load Transfer Simulation by Electromechanical Inertia Compensation

Dynamic modeling and brake stick-slip vibration analysis of a vehicle-track system with disc-pad nonlinear frictions

Study on ride comfort in post-braking phase based on brake-by-wire system

Research on Variable Transmission Ratio Control Method to Improve Vehicle Handling Comfort Based on Steer-by-Wire System

An Analysis of Shimmy in Braking Procession of the Middle Truck

Experiment on Hydraulic Disk Brake Model

Braking Control Performances of a Disk-Type Magneto-Rheological Brake Via Hardware-in-the-loop Simulation

Research on control strategy and bench test of automobile Steer-by-Wire system

Application of Dynamic Vibration Absorber to Optimization of NVH Property of Steering Wheels

Brake Compensation Control for In-wheel Motor Drive System Failure

Integrated control of braking-yaw-roll stability under steering-braking conditions