Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Numerical analysis of metal/ceramic bilayer materials systems in laser forming

An Analytical Model for Bending Angle in Metal/ceramic Bilayer System of Laser Forming

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Numerical study on laser forming of metal plates with pre-loads

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Numerical analysis of laser-controlled thermal stress cutting of an alumina ceramic

Numerical Simulation of the Laser Forming of Plates Using Two Simultaneous Scans

Three-dimensional Thermal Analysis for Laser Assisted Machining of Ceramics Using FEA

High Temperature Deformation Mechanisms and Constitutive Modeling for Al/SiCp/45 Metal Matrix Composites Undergoing Laser-Assisted Machining

Numerical Modeling and Mechanism Analysis of Hybrid Heating and Shock Process for Laser-Assisted Laser Peen Forming

Numerical Study on Deformation Behaviors in Intersecting Rectilinear Laser Bending

Laser Forming of Plates Using Two Sequent Scans of Different Intervals

A NUMERICAL SIMULATION AND EXPERIMENTAL STUDY ON TOUGHENING DESIGN OF MULTILAYER CERAMIC

A Finite Element Model Using Multi-Layered Shell Element in Laser Forming

Investigation on the Curvature and Stress Distribution of Laminates Based on an Analytic Solution and FE Simulation

Research on the mechanisms of laser forming for the metal plate

Scan Pattern, Stress and Mechanical Strength of Laser Directly Sintered Ceramics

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Quantitative analysis and experimental study of the influence of process parameters on the evolution of laser cladding

Numerical Simulation and Experimental Investigation of Laser Ablation of Al2O3 Ceramic Coating

Dynamic Analysis on Laser Forming of Square Metal Sheet to Spherical Dome