Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Comparisons of Heat Transfer Performance of Different Refrigerants in Condenser for Air Conditioning

Experimental study on the cycle performance of refrigerant R32

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Preliminary study on the performance of the diffusion absorption refrigerator operating with the mixed refrigerant

Experimental study of ternary mixture R32/R125/R161 as alternative refrigerant to R407C

SIMULATION AND COMPARISON OF AIR-SOURCE HEAT PUMPS USING VARIABLE COMPOSITION AND CONSTANT COMPOSITION MIXTURES OR PURE REFRIGERANT

Energy efficiency of a reversible refrigeration unit using R410A or R32

Review of the Application of R32 on Air Conditioners and Heat Pump Systems

Experimental Evaluation of Condensation of R32 and R134a over a Plain Tube

A Comparative Study of Fin-And-Tube Heat Exchangers With and Without Liquid-Vapor Separation in Air Conditioning Units

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

ANALYSIS OF THE PERFORMANCE DIFFERENCE OF MEDIUM-HIGH TEMPERATURE REFRIGERANT ON

Evaporation Heat Transfer and Pressure Drop of R161 in A 7 Mm Micro-Fin Tube

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Application Research for Pump-driven Loop Heat Pipe System Using R32 to Replace R22

Performance comparison of refrigerants used in low ambient temperature air source heat pump for railway vehicle

Comparison Of Evaporation And Condensation Characteristics Among Three Enhanced Tubes

Comparison Of R410a Condensation Heat Transfer Performance On Three Horizontal Tubes

Experimental study on condensation heat transfer of R32, R152a and R22 in horizontal minichannels

Numerical Simulation on Heat and Mass Transfer of Plate Evaporative Condenser